Improving the reliability of the iron concentration quantification for iron oxide nanoparticle suspensions: a two-institutions study
Open Access
- 12 November 2018
- journal article
- research article
- Published by Springer Nature in Analytical and Bioanalytical Chemistry
- Vol. 411 (9) , 1895-1903
Abstract
Most iron oxide nanoparticles applications, and in special biomedical applications, require the accurate determination of iron content as the determination of particle properties from measurements in dispersions is strongly dependent on it. Inductively coupled plasma (ICP) and spectrophotometry are two typical worldwide used analytical methods for iron concentration determination. In both techniques, precise determination of iron is not straightforward and nanoparticle digestion and dilution procedures are needed prior to analysis. The sample preparation protocol has been shown to be as important as the analytical method when accuracy is aimed as many puzzling reported results in magnetic, colloidal, and structural properties are simply attributable to inadequate dissolution procedures. Therefore, a standard sample preparation protocol is needed to ensure the adequate and complete iron oxide nanoparticle dissolution and to harmonize this procedure. In this work, an interlaboratory evaluation of an optimized iron oxide nanoparticle digestion/dilution protocol was carried out. The presented protocol is simple, inexpensive, and does not involve any special device (as microwave, ultrasound, or other high-priced digestion devices). Then, iron concentration was measured by ICP-OES (performed in ICMM/CSIC-Spain) and spectrophotometry (NanoPET-Germany) and the obtained concentration values were analyzed to determine the most probable error causes. Uncertainty values as low as 1.5% were achieved after the optimized method was applied. Moreover, this article provides a list of recommendations to significantly reduce uncertainty in both sample preparation and analysis procedures. Graphical abstractKeywords
Funding Information
- Ministerio de Ciencia e Innovación (MAT2017-88148-R)
- FP7 Nanosciences, Nanotechnologies, Materials and new Production Technologies (Nanomag 604448)
This publication has 25 references indexed in Scilit:
- Considerations for measuring iron in post-mortem tissue of Parkinson’s disease patientsJournal of Neural Transmission, 2012
- ESI-MS quantitation of iron as its 4-(2-pyridylazo)resorcinol (PAR) complex: application to pharmaceutical tablets containing iron oxide pigmentJournal of Mass Spectrometry, 2011
- Effect of Nanoparticle and Aggregate Size on the Relaxometric Properties of MR Contrast Agents Based on High Quality Magnetite NanoparticlesThe Journal of Physical Chemistry B, 2009
- Tailored Magnetic Nanoparticles for Direct and Sensitive Detection of Biomolecules in Biological SamplesNano Letters, 2008
- Uniform and water stable magnetite nanoparticles with diameters around the monodomain–multidomain limitJournal of Physics D: Applied Physics, 2008
- Generation of magnetic nonviral gene transfer agents and magnetofection in vitroNature Protocols, 2007
- The uncertainty of UV–Vis spectrophotometric and FAAS analysis for the determination of iron in pharmaceutical productsAccreditation and Quality Assurance, 2007
- Size Distribution of Superparamagnetic Particles Determined by Magnetic SedimentationLangmuir, 2007
- Nanoscale Size Effect of Magnetic Nanocrystals and Their Utilization for Cancer Diagnosis via Magnetic Resonance ImagingJournal of the American Chemical Society, 2005
- A rapid method for iron determination in fortified foodsFood Chemistry, 2001