Influence of particulate reinforcement on microstructure evolution and tensile properties of in-situ polymer derived MMC by friction stir processing
Authors:
- Ajay Kumar P.APAjay Kumar P.
- Devinder YadavDYDevinder Yadav
- Chandra S. PeruguCPChandra S. Perugu
- Satish V. KailasSKSatish V. Kailas
- 1 January 2017
- journal article
- Published by Elsevier in Materials & Design
- Vol. 113, 99-108
Abstract
No abstract availableKeywords
This publication has 48 references indexed in Scilit:
- A Novel In Situ Method for Producing a Dispersion of a Ceramic Phase into Copper That Remains Stable at 0.9T MMetallurgical and Materials Transactions A, 2013
- Microstructure Development in Single and Double-Pass Friction Stir Processing of AluminiumMaterials Science Forum, 2013
- Reactive mechanism and mechanical properties of in situ composites fabricated from an Al–TiO2 system by friction stir processingActa Materialia, 2012
- Fabrication of in situ Cu/SiC composites using multi-pass friction stir processing: Evaluation of microstructural, porosity, mechanical and electrical behaviorComposites Part A: Applied Science and Manufacturing, 2011
- Microstructures and mechanical properties of Al/Al2O3 surface nano-composite layer produced by friction stir processingMaterials Science and Engineering: A, 2009
- Effect of friction stir processing on the microstructure of cast A356 aluminumMaterials Science and Engineering: A, 2006
- The joint properties of copper by friction stir weldingMaterials Letters, 2004
- Physics and phenomenology of strain hardening: the FCC caseProgress in Materials Science, 2003
- Copper matrix SiC and Al2O3 particulate composites by powder metallurgy techniqueMaterials Letters, 2002
- A Review of the Stages of Work HardeningSolid State Phenomena, 1993