Transverse modes in one-port SAW resonators
Authors:
- 1 November 1992
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control
- Vol. 39 (6) , 785-787
Abstract
The S/sub 11/ and equivalent S/sub 21/ frequency responses of a one-port surface acoustic wave (SAW) resonator with transverse modes derived from one-dimensional coupling-of-modes and transmission-matrix analysis. The two-dimensional nature of the problem is approximated by a summation of one-dimensional mode responses for each transverse mode. Comparison between theory and experimental data for a commercial 280-MHz one-port SAW resonator shows good agreement for the placement of transverse modes.<>Keywords
This publication has 9 references indexed in Scilit:
- Modelling the transverse-mode response of a two-port SAW resonatorIEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 1991
- Self-Suppression Effects of Spurious Transverse Modes in SAW Reflectors and Resonators with a Positive and Negative Reflectivity1985
- Surface Acoustic Wave Resonators on QuartzIEEE Transactions on Sonics and Ultrasonics, 1979
- Surface-acoustic-wave resonator filtersProceedings of the IEEE, 1979
- Coupled Surface-Acoustic-Wave ResonatorsBell System Technical Journal, 1977
- Coupled slot waveguide s.a.w. resonatorsElectronics Letters, 1977
- The Design of SAW Resonators on Quartz with Emphasis on Two Ports1976
- Surface Acoustic Wave Resonators on ST-Quartz1975
- UHF Surface Acoustic Wave Resonators1974