A Novel Modular Stator Fractional Pole-Pair Permanent-Magnet Vernier Machine With Low Torque Ripple for Servo Applications
- 18 August 2020
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Magnetics
- Vol. 57 (2) , 1-6
Abstract
In recent years, high-precision servo systems have attracted much attention due to the development of aerospace and electronic industries. Given the requirement of the servo systems, the machine torque ripple, including the no-load cogging torque and the load torque ripple, must be limited under a low level to achieve the high precision. The ironless permanent magnet-machine (ironless PMM) is usually adopted in high-precision servo systems due to its characteristics of zero cogging torque and low torque ripple. However, ironless PMM has a lot of drawbacks such as low torque density and large PM consumption, making the system size large and expensive. The permanent-magnet vernier machine (PMVM) is also studied for servo applications for its low torque ripple and large torque density due to the adoption of the so-called magnetic gearing effect. However, its torque ripple is still apparently larger than that of the ironless PMM. In order to achieve low torque ripple and large torque density at the same time, a novel modular stator fractional pole-pair PMVM (MFP-PMVM) is proposed and analyzed in this article. The cogging torque and torque ripple of the proposed MFP-PMVM is 93% and 70% lower than that of the conventional PMVM without an obvious decrease on the rated torque. The proposed MFP-PMVM exhibits a low torque ripple close to the ironless PMM while the torque density and PM utilization of the proposed MFP-PMVM is 163% and 14 times higher than that of the ironless PMM. Based on the finite-element method (FEM) results, the superiorities of the proposed MFP-PMVM are verified.Keywords
Funding Information
- National Natural Science Foundation of China (51761135120, 51991382, 51520105010, 51807076)
- Graduates’ Innovation Fund of Huazhong University of Science and Technology (2019YGSCXCY010)
This publication has 13 references indexed in Scilit:
- Cogging torque minimization of SMC motor with axially tapered stator tooth tip2017
- 3D magnetic and thermal stress analysis of a direct liquid-cooled coreless linear actuator2016
- Analysis of cogging torque in surface permanent magnet machine with manufacturing tolerances2015
- Synthesis of Flux Switching Permanent Magnet MachinesIEEE Transactions on Energy Conversion, 2015
- Analysis of Torque Capability and Quality in Vernier Permanent-Magnet MachinesIEEE Transactions on Industry Applications, 2015
- Operation and Design Principles of a PM Vernier MotorIEEE Transactions on Industry Applications, 2014
- Reduction of Torque Ripple Due to Demagnetization in PMSM Using Current CompensationIEEE Transactions on Applied Superconductivity, 2010
- Optimization for Reduction of Torque Ripple in an Axial Flux Permanent Magnet MachineIEEE Transactions on Magnetics, 2009
- Influence of design parameters on cogging torque in permanent magnet machinesIEEE Transactions on Energy Conversion, 2000
- Generic torque-maximizing design methodology of surface permanent-magnet vernier machineIEEE Transactions on Industry Applications, 2000