Drag Coefficients of Latticed Towers
Author:
- 1 February 1986
- journal article
- Published by American Society of Civil Engineers (ASCE) in Journal of Structural Engineering
- Vol. 112 (2) , 417-430
Abstract
Recent building codes require that wind loads be determined by multiplying a calculated velocity pressure by the drag coefficient of the structure. It is suggested that the drag coefficients given in the codes for latticed towers are conservative. To determine appropriate drag coefficients for square self‐supported latticed towers two models were constructed and tested in a wind tunnel. Drag forces of the two models with and without heel angles as well as half of one model and tilting to different angles of the other model were determined. Results are analyzed and drag coefficients are calculated and compared to other published test results and to the ANSI A58.1 Code. Recommended equations are given for determining the drag coefficient of latticed towers with solidity ratios in a given range. For the wind direction on the diagonal axis of the tower the drag was found to be independent of the solidity ratio and, therefore, a multiplier is recommended. A multiplier is also recommended for towers with legs t...Keywords
This publication has 6 references indexed in Scilit:
- ON WIND-PROOF PERFORMANCE OF LATTICED STEEL TOWERS1980
- WIND LOADS ON BUILDING FRAMES1980
- THE DEVELOPMENT OF THE BRITISH DRAFT CODE OF PRACTICE FOR THE LOADING OF LATTICE TOWERS1980
- THE INFLUENCE OF SHIELDING ON THE WIND FORCES EXPERIENCED BY ARRAYS OF LATTICE FRAMES1980
- CALCULATION OF WIND FORCES AND PRESSURES ON ANTENNASAnnals of the New York Academy of Sciences, 1964
- Wind pressure on latticed towers—tests on modelsJournal of the Institution of Electrical Engineers, 1935