Preparation of polypropylene/carbon nanotube composite powder with a solid‐state mechanochemical pulverization process
Authors:
- 14 April 2004
- journal article
- research article
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 93 (1) , 378-386
Abstract
A solid‐state mechanochemical pulverization process, that is, pan milling, was used to prepare a polypropylene (PP)/carbon nanotube (CNT) composite powder. The composite powder was then melt‐mixed with a twin‐roll masticator to obtain a PP/CNT composite. The morphology of the PP/CNT powder and the PP/CNT composite was investigated. The crystallization and mechanical properties of the latter were also studied. After 20 milling cycles (ca. 60 min), the average diameter of PP/3 wt % CNT composite powder particles was a few micrometers. The length of the CNTs was reduced from a few micrometers to 0.4–0.5 μm. The CNTs became straighter and more uniform in length. The effects of incorporating the CNTs into PP were as follows: (1) the crystallization rate and temperature of PP increased, (2) a strong b‐plane orientation of PP was induced, and (3) the Young's modulus and yield strength of PP increased. Interfacial adhesion between PP and the CNTs was improved by the mechanical action of the solid‐state pulverization process used, which favored the dispersion of the CNTs into PP. © 2004 Wiley Periodicals, Inc. J Appl Polym Sci 93: 378–386, 2004Keywords
This publication has 33 references indexed in Scilit:
- Crystallization and orientation studies in polypropylene/single wall carbon nanotube compositePolymer, 2003
- Multiwalled carbon nanotube polymer composites: Synthesis and characterization of thin filmsJournal of Applied Polymer Science, 2002
- Functionalizing Multiple-Walled Carbon Nanotubes with AminopolymersThe Journal of Physical Chemistry B, 2002
- Advances in the science and technology of carbon nanotubes and their composites: a reviewComposites Science and Technology, 2001
- Solid‐phase preparation of ultra‐fine PA6 powder through pan‐millingPolymer Engineering & Science, 2001
- A study on the pan‐milling process and the pulverizing efficiency of pan‐mill type equipmentPolymer Engineering & Science, 1997
- Aligned Carbon Nanotube Arrays Formed by Cutting a Polymer Resin—Nanotube CompositeScience, 1994
- Crystal orientation in injection molding of talc‐filled polypropyleneJournal of Applied Polymer Science, 1991
- Orientation in composite of polypropylene and talcJournal of Applied Polymer Science, 1989
- Physical and dynamic mechanical properties of ultradrawn polypropylene filmsMacromolecules, 1988