Microstructure‐properties correlations in dynamically vulcanized nanocomposite thermoplastic elastomers based on PP/EPDM
Authors:
- 6 February 2007
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 47 (3) , 207-217
Abstract
Thermoplastic vulcanized (TPV) nanocomposites were prepared in a laboratory mixer using EPDM, polypropylene of different viscosities, maleic anhydride modified polypropylene, an organo‐clay, and a sulfur‐based curing system. Based on the obtained results from X‐ray diffraction, transmission electron microscopy (TEM), scanning electron microscopy (SEM), differential scanning calorimeter, and mechanical properties, the microstructure of the prepared nanocomposites was found to be sensitive to the viscosity difference between the two phases and the clay content. X‐ray diffraction and TEM images of the TPV nanocomposites showed that clay was nearly exfoliated and randomly distributed into the polypropylene phase. The SEM photomicrographs of the dynamically vulcanized thermoplastic elastomer samples showed that the rubber particles were dispersed through the polypropylene in form of aggregates and their size increased with the introduction of clay. The nanoscale dimensions of the dispersed clay resulted in a significant improvement of the tensile modulus of the TPV nanocomposite samples, from 20 to 90% depending on clay content and the viscosity ratio of PP/EPDM. In the PP nanocomposites, the clay layers act as nucleating agents, resulting in higher crystallization temperature and reduced degree of crystallinity. Moreover, the oxygen permeability in the TPV nanocomposites was found to be lower than in unfilled but otherwise similar materials. POLYM. ENG. SCI., 47:207–217, 2007. © 2007 Society of Plastics Engineers.Keywords
This publication has 27 references indexed in Scilit:
- PP–PP‐g‐MAH–Org‐MMT nanocomposites. I. Intercalation behavior and microstructureJournal of Applied Polymer Science, 2003
- Formation of Rubber Particle Agglomerates During Morphology Development in Dynamically Crosslinked EPDM/PP Thermoplastic Elastomers. Part 1: Effects of Processing and Polymer Structural ParametersRubber Chemistry and Technology, 2003
- Polypropylene/Clay nanocomposites: Effect of compatibilizer on the thermal, crystallization and dynamic mechanical behaviorPolymer Engineering & Science, 2002
- PP/clay nanocomposites prepared by grafting-melt intercalationPolymer, 2001
- Polymeric Nanocomposites for Automotive ApplicationsAdvanced Materials, 2000
- Polyolefin‐clay hybrids based on modified polyolefins and organophilic clayMacromolecular Materials and Engineering, 2000
- Finite element analysis of flow of thermoplastic elastomer melt through axisymmetric die with slip boundary conditionPlastics, Rubber and Composites: Macromolecular Engineering, 2000
- Carbon black-reinforced dynamically cured EPDM/PP thermoplastic elastomers. I. Morphology, rheology, and dynamic mechanical propertiesJournal of Applied Polymer Science, 2000
- The Morphology of Rubber/Plastic BlendsRubber Chemistry and Technology, 1997
- Structure development during dynamic vulcanization of hydrogenated nitrile rubber/nylon blendsJournal of Applied Polymer Science, 1993