Laser–material interaction and grooving performance in ultrafast laser ablation of crystalline germanium under ambient conditions
- 15 July 2013
- journal article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture
- Vol. 227 (11) , 1714-1723
Abstract
Microgrooving on crystalline germanium (Ge) surface using 1064 nm wavelength ultrafast laser pulses under ambient condition is investigated. The interaction of laser and target material and the influence of processing parameters such as laser power, pulse repetition rate and scan speed on the groove dimensions and surface roughness are studied. For the laser radiation fluence range used (0.4–0.8 J/cm2), material removal is primarily controlled by optical penetration depth. The depth and width of grooves increase with laser power. In multipulse irradiation, heat accumulation due to residual thermal energy from successive laser pulses results in a greater material removal. Furthermore, groove depth and width decrease as the pulse repetition rate increases from 0.5 to 2 MHz, due to the decrease in pulse energy with an increase in repetition rate causing ablation threshold fluence to move towards the central portion of the Gaussian pulse. Surface roughness has not shown significant changes for the parameters used in this study. A micro-Raman analysis of groove surfaces reveals a change in the crystallinity of the Ge due to laser irradiation.Keywords
This publication has 26 references indexed in Scilit:
- High-aspect-ratio grooves fabricated in silicon by a single pass of femtosecond laser pulsesJournal of Applied Physics, 2012
- Non-thermal excitation and control of magnetization in Fe/GaAs film by ultrafast laser pulsesJournal of Applied Physics, 2012
- Femtosecond laser crystallization of amorphous GeJournal of Applied Physics, 2011
- Study of silicon nanofibrous structure formed by femtosecond laser irradiation in airOptics Express, 2009
- Femtosecond laser micromilling of Si wafersApplied Surface Science, 2008
- Preparation of Room-Temperature Photoluminescent Nanoparticles by Ultrafast Laser Processing of Single-Crystalline GeJapanese Journal of Applied Physics, 2005
- Ultrafast x-ray measurement of laser heating in semiconductors: Parameters determining the melting thresholdPhysical Review B, 2001
- Laser-Induced Damage in Dielectrics with Nanosecond to Subpicosecond PulsesPhysical Review Letters, 1995
- Optical heating in semiconductors: Laser damage in Ge, Si, InSb, and GaAsJournal of Applied Physics, 1980
- Ultrafast transient response of solid-state plasmas. I. Germanium, theory, and experimentPhysical Review B, 1977