Photoelectrochemical treatment of ammonium using seawater as a natural supporting electrolyte
- 1 January 2013
- journal article
- research article
- Published by Taylor & Francis in Chemistry and Ecology
- Vol. 29 (1) , 72-85
Abstract
In the present study, a photoelectrochemical process containing seawater as a natural low-cost supporting electrolyte was used to remove ammonium from wastewater in a continuous flow mode. Based on central composite design (CCD), response surface methodology (RSM) was employed to evaluate the performance of the process in ammonia removal. The effect of four main independent parameters, including initial ammonium concentration, hydraulic retention time (HRT), current intensity and initial pH on the removal of ammonia was evaluated by the model. The optimal initial ammonium concentration, HRT, current intensity and initial pH were 917 mg NH 4− N;·L −1, 108 min, 1.8 A and 8.4, respectively. The high coefficients (R 2=0.97 and adjusted R 2=0.94) obtained by the analysis of variance (ANOVA) demonstrated close correlation between predicted and experimental values. Also, treating the reject water from the sludge dewatering unit as an ammonium-rich wastewater showed the effectiveness of the process for treating real wastewaters (86% ammonium removal). The results revealed that the present process can be an efficient method for ammonium removal from polluted effluents in coastal areas based on the availability of seawater as a cost-efficient supporting electrolyte.Keywords
This publication has 38 references indexed in Scilit:
- The Kinetics for Electrochemical Removal of Ammonia in Coking WastewaterChinese Journal of Chemical Engineering, 2011
- Evaluation of electro-oxidation of biologically treated landfill leachate using response surface methodologyJournal of Hazardous Materials, 2011
- Redistribution of wastewater alkalinity with a microbial fuel cell to support nitrification of reject waterWater Research, 2011
- Solar photoelectro-Fenton degradation of paracetamol using a flow plant with a Pt/air-diffusion cell coupled with a compound parabolic collector: Process optimization by response surface methodologyApplied Catalysis B: Environment and Energy, 2011
- Multivariate analysis of anionic, cationic and nonionic textile surfactant degradation with the H2O2/UV-C process by using the capabilities of response surface methodologyJournal of Hazardous Materials, 2011
- Electrochemical process combined with UV light irradiation for synergistic degradation of ammonia in chloride-containing solutionsWater Research, 2009
- Removal of ammonium ion from produced waters in petroleum offshore exploitation by a batch single-stage electrolytic processJournal of Hazardous Materials, 2009
- Electrochemical treatment of anaerobic digestion effluent using a Ti/Pt–IrO2 electrodeBioresource Technology, 2007
- Photocatalytic and electrochemical combined treatment of textile wash waterJournal of Hazardous Materials, 2007
- Influence of operating conditions on the ammonia electro-oxidation rate in wastewaters from power plants (ELONITA™ technique)Water Research, 2005