Bearing Behavior of Joints in Pultruded Composites
Author:
- 1 September 2002
- journal article
- Published by SAGE Publications in Journal of Composite Materials
- Vol. 36 (18) , 2199-2216
Abstract
Due to the increased use of pultruded composites for structural applications, understanding the bearing behavior of pultruded composites is important for effective structural designs. This paper reports on a comprehensive experimental and analytical study to characterize the influence of geometry and loading condition on the joint strength and failure mode in pultruded composites. The geometric parameters studied were specimen width, end distance, and hole diameter. The experimental study included compressive and tensile bearing tests. The results provide useful information for the structural design with such materials against joint failures. The experimental results for tensile failure load and failure mode are compared with predictions from the tensile, shear and (compressive) bearing strengths based on both average stress analysis and finite element method (FEM). The effect of hole size on the compressive bearing strength was analyzed and good correlation between predictions and test results was observed. The effect of further reinforcing the pultruded composites with a woven fabric was evaluated.Keywords
This publication has 11 references indexed in Scilit:
- Bearing behavior of triaxially braided flat and tubular compositesApplied Composite Materials, 1994
- The experimental behaviour of bolted joints in pultruded glass/ polyester material. Part 1: Single-bolt jointsComposites, 1993
- The strength of bolted joints in glass fibre/epoxy laminatesComposites, 1985
- Failure of Composite Laminates Containing Pin Loaded Holes—Method of SolutionJournal of Composite Materials, 1984
- The losipescu shear test as applied to composite materialsExperimental Mechanics, 1983
- Strength of Mechanically Fastened Composite JointsJournal of Composite Materials, 1982
- On the bearing strengths of cfrp laminatesComposites, 1982
- Stresses Around Pin-Loaded Holes in Elastically Orthotropic or Isotropic PlatesJournal of Composite Materials, 1977
- Failure Mode and Strength Predictions of Anisotropic Bolt Bearing SpecimensJournal of Composite Materials, 1971
- A General Theory of Strength for Anisotropic MaterialsJournal of Composite Materials, 1971