Effect of ILU dispensing types for different solder bump arrangements on CUF encapsulation process
- 1 September 2016
- journal article
- Published by Elsevier in Microelectronic Engineering
- Vol. 163, 83-97
Abstract
No abstract availableKeywords
Funding Information
- Ministry of Higher Education, Malaysia (6071322)
- Universiti Sains Malaysia, Penang (60313020)
This publication has 20 references indexed in Scilit:
- Underfill process for two parallel plates and flip chip packagingInternational Communications in Heat and Mass Transfer, 2012
- Investigation of the fluid/structure interaction phenomenon in IC packagingMicroelectronics Reliability, 2012
- Study on the fluid/structure interaction at different inlet pressures in molded packagingMicroelectronic Engineering, 2011
- Three-dimensional simulation of underfill process in flip-chip encapsulationComputers & Fluids, 2011
- A Study on the Effect of Epoxy Molding Compound (EMC) Rheology During Encapsulation of Stacked-CHIP Scale Packages (S-CSP)Journal of Reinforced Plastics and Composites, 2008
- Thermal performance of flip chip packages: Numerical study of thermo-mechanical interactionsComputational Materials Science, 2008
- Recent Advances in Flip-Chip Underfill: Materials, Process, and ReliabilityIEEE Transactions on Advanced Packaging, 2004
- Three-Dimensional Modeling of Mold Filling in Microelectronics Encapsulation ProcessIEEE Transactions on Components and Packaging Technologies, 2004
- Numerical simulation of mold filling in injection molding using a three‐dimensional finite volume approachInternational Journal for Numerical Methods in Fluids, 2001
- Thermal characterization of an epoxy-based underfill material for flip chip packagingThermochimica Acta, 2000