Flow Boiling Heat Transfer of CO2 at Low Temperatures in a Horizontal Smooth Tube
Authors:
- 18 March 2005
- journal article
- Published by Wiley in Journal of Heat Transfer
- Vol. 127 (12) , 1305-1312
Abstract
Flow boiling heat transfer coefficients of CO2 are measured in a horizontal smooth tube with inner diameter 6.1mm. The test tube is heated by a secondary fluid maintaining constant wall temperature conditions. Heat transfer coefficients are measured at evaporation temperatures of −15 and −30°C, mass flux from 100to400kg∕m2s, and heat flux from 5to15kW∕m2 for qualities (vapor mass fractions) ranging from 0.1 to 0.8. The characteristics of CO2 flow boiling are explained by CO2 properties and flow patterns. The measured CO2 heat transfer coefficients are compared to other published data. Experiments with R22 were also conducted in the same system and the results show that the heat transfer coefficients for CO2 are 40 to 150% higher than for R22 at −15°C and low mass flux of 200kg∕m2s mostly due to the characteristics of CO2 nucleate boiling. The presented CO2 heat transfer coefficients indicate the reduction of heat transfer coefficient as mass flux increases at low quality regions and also show that dryout does not occur until the high quality region of 0.8, for mass fluxes of 200 and 400kg∕m2s. The Gungor and Winterton correlation gives a relatively good agreement with measured data; however it deviates more at lower evaporation temperature and high mass flux conditions.Keywords
This publication has 13 references indexed in Scilit:
- Pool boiling heat transfer of carbon dioxide on a horizontal tubeInternational Journal of Refrigeration, 2005
- Flow boiling heat transfer to carbon dioxide: general prediction methodInternational Journal of Refrigeration, 2004
- Characteristics of evaporative heat transfer and pressure drop of carbon dioxide and correlation developmentInternational Journal of Refrigeration, 2004
- Boiling heat transfer and dryout phenomenon of CO2 in a horizontal smooth tubeInternational Journal of Heat and Mass Transfer, 2003
- Flow Boiling in Horizontal Tubes: Part 3—Development of a New Heat Transfer Model Based on Flow PatternJournal of Heat Transfer, 1998
- Flow Boiling in Horizontal Tubes: Part 1—Development of a Diabatic Two-Phase Flow Pattern MapJournal of Heat Transfer, 1998
- Flow Boiling Heat Transfer in Vertical Tubes Correlated by an Asymptotic ModelHeat Transfer Engineering, 1992
- A General Correlation for Saturated Two-Phase Flow Boiling Heat Transfer Inside Horizontal and Vertical TubesJournal of Heat Transfer, 1990
- A general correlation for flow boiling in tubes and annuliInternational Journal of Heat and Mass Transfer, 1986
- On the Conditions of Incipient Subcooled-Boiling with Forced ConvectionBulletin of JSME, 1964