Normally-off gate-recessed AlGaN/GaN-on-Si hybrid MOS-HFET with Al2O3 gate dielectric
Authors:
- 1 June 2011
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 213-214
Abstract
GaN-based HFETs offer a combination of high breakdown field, high current densities, and low on-resistance, making them well-suited for power-switching applications. Normally-off FETs are preferred in power switching applications for circuit simplicity and safety. Recently, a new type of normally-off GaN device has been reported: the hybrid metal-oxide-semiconductor (MOS)- or metal-insulator-semiconductor (MIS)-HFET, consisting of an MOS-type structure under the gate for normally-off operation and an HFET-like structure in the access regions for low on-resistance. Optimization of the insulator-epi interface and insulator quality is critical for this type of device, since the electrons under gate electrode are in direct contact with the gate insulator. Previous reports of hybrid MOS-HFETs used SiO 2 or SiN gate dielectrics deposited by plasma-enhanced chemical vapor deposition (PECVD). However, alternative deposition methods such as atomic layer deposition (ALD) have been shown to result in superior thickness control, uniformity, conformality, and film quality, while ALD high-k gate dielectrics such as Al 2 O 3 have generated significant interest for GaN HFETs due to excellent GaN interface quality. In this work, we fabricated normally-off AlGaN/GaN hybrid MOS-HFETs on (111) Si substrates using gate recess etching combined with an ALD Al 2 O 3 gate dielectric for low gate leakage, low on-resistance, and high breakdown voltage. The gate fabrication process was optimized to reduce the trap density associated with the dielectric and eliminate threshold voltage hysteresis, which can result from slow traps in the dielectric or at the dielectric-epi interface. A three-terminal breakdown voltage (V B ) of 1370V was measured at a gate bias of 0 V on a device with a 20 mm gate periphery and a low specific on-resistance (R on ) of 9.0 mΩ-cm 2 . The resulting V B 2 /R on figure of merit of 208 MW/cm 2 is among the highest values reported to-date for normally-off GaN-on-Si HFETs.Keywords
This publication has 9 references indexed in Scilit:
- High field-effect mobility normally-off AlGaN/GaN hybrid MOS-HFET on Si substrate by selective area growth techniqueSolid-State Electronics, 2011
- Self-aligned ALD AlOx T-gate insulator for gate leakage current suppression in SiNx-passivated AlGaN/GaN HEMTsSolid-State Electronics, 2010
- Over 100A operation normally-off AlGaN/GaN hybrid MOS-HFET on Si substrate with high-breakdown voltageSolid-State Electronics, 2010
- GaN Power Transistors on Si Substrates for Switching ApplicationsProceedings of the IEEE, 2010
- Low On-Resistance High-Breakdown Normally Off AlN/GaN/AlGaN DHFET on Si SubstrateIEEE Electron Device Letters, 2010
- Single-Chip Boost Converter Using Monolithically Integrated AlGaN/GaN Lateral Field-Effect Rectifier and Normally Off HEMTIEEE Electron Device Letters, 2009
- AlGaN/GaN Recessed MIS-Gate HFET With High-Threshold-Voltage Normally-Off Operation for Power Electronics ApplicationsIEEE Electron Device Letters, 2008
- Gate Injection Transistor (GIT)—A Normally-Off AlGaN/GaN Power Transistor Using Conductivity ModulationIEEE Transactions on Electron Devices, 2007
- Enhancement-Mode AlGaN/AlN/GaN High Electron Mobility Transistor with Low On-State Resistance and High Breakdown VoltageJapanese Journal of Applied Physics, 2006