Drop impact printing
Open Access
- 28 August 2020
- journal article
- research article
- Published by Springer Nature in Nature Communications
- Vol. 11 (1) , 1-11
Abstract
Hydrodynamic collapse of a central air-cavity during the recoil phase of droplet impact on a superhydrophobic sieve leads to satellite-free generation of a single droplet through the sieve. Two modes of cavity formation and droplet ejection have been observed and explained. The volume of the generated droplet scales with the pore size. Based on this phenomenon, we propose a drop-on-demand printing technique. Despite significant advancements in inkjet technology, enhancement in mass-loading and particle-size have been limited due to clogging of the printhead nozzle. By replacing the nozzle with a sieve, we demonstrate printing of nanoparticle suspension with 71% mass-loading. Comparatively large particles of 20 μm diameter are dispensed in droplets of ~80 μm diameter. Printing is performed for surface tension as low as 32 mNm−1 and viscosity as high as 33 mPa∙s. In comparison to existing techniques, this way of printing is widely accessible as it is significantly simple and economical.Keywords
All Related Versions
Funding Information
- Ministry of Human Resource Development
This publication has 48 references indexed in Scilit:
- Development of a valve-based cell printer for the formation of human embryonic stem cell spheroid aggregatesBiofabrication, 2013
- Optimization of Experimental Parameters to Suppress Nozzle Clogging in Inkjet PrintingIndustrial & Engineering Chemistry Research, 2012
- Direct Human Cartilage Repair Using Three-Dimensional Bioprinting TechnologyTissue Engineering Part A, 2012
- Inkjet-Printed Graphene ElectronicsACS Nano, 2012
- Synthesis of silver nano particles and fabrication of aqueous Ag inks for inkjet printingMaterials Chemistry and Physics, 2011
- Three-dimensional inkjet biofabrication based on designed imagesBiofabrication, 2011
- The dynamics of the piezo inkjet printhead operation☆Physics Reports, 2010
- Direct Inkjet Printing of Dental Prostheses Made of ZirconiaJournal of Dental Research, 2009
- Ejection Characteristics and Drop Modulation of Acoustic Inkjet Printing Using Fresnel LensJournal of Fluid Science and Technology, 2009
- Singular Jets and Bubbles in Drop ImpactPhysical Review Letters, 2006