Real-Time Feedback of the Applied Light-Curing Technique and Its Impact on Degree of Conversion of Composite Restorations—A Study with Undergraduate Dental Students
Open Access
- 9 October 2021
- journal article
- research article
- Published by MDPI AG in Journal of Personalized Medicine
- Vol. 11 (10) , 1012
Abstract
The objective of this study was to investigate the effect of individual instructions and training of dental students on the amount of applied light irradiance before and after training using a patient simulator with integrated visual feedback. Furthermore, the effect on the degree of conversion of composite restorations placed by the dental students was assessed. Forty-two dental students, split into two groups, light-cured a simulated restoration in tooth 27 of a dental patient simulator for 20 s. The irradiance (mW/cm2) received by the detector was measured in real-time before and after individual instructions and training, and the energy delivered (J/cm2) was calculated for each student. The degree of conversion at the bottom of incrementally placed composite restorations prior to individual instructions (group 1) and after individual instructions (group 2) was assessed using Fourier-transform infrared (FTIR) spectroscopy. The irradiance and degree of conversion measurements were re-assessed after all students received individual instructions. Data were analyzed using Wilcoxon signed-rank test and Mann-Whitney U-test at an overall level of significance of α = 0.05. A significant increase (p < 0.001) in applied light irradiance could be observed after individual instructions for both groups, with notably reduced data scattering. However, no significant difference was detected for the degree of conversion of placed composite restorations before or after instruction and training. Neither gender nor age of the dental students affected the obtained results. Consistent light energy delivered by dental students could be achieved through individual instructions and training with a patient simulator, also leading to less scattered irradiance results. However, the improved light-curing performance after the training did not affect the degree of conversion of the placed class II composite restorations.Keywords
Funding Information
- Foundation for Research in Science and the Humanities (-)
This publication has 38 references indexed in Scilit:
- Progress in dimethacrylate-based dental composite technology and curing efficiencyDental Materials, 2013
- Guest EditorialDental Materials, 2013
- Durability of the anti-erosive effect of surfaces sealants under erosive abrasive conditionsActa Odontologica Scandinavica, 2012
- Longevity of posterior composite restorations: Not only a matter of materialsDental Materials, 2012
- Influence of Prolonged Light-curing Time on the Shear Bonding Strength of Resin to Bleached EnamelOperative Dentistry, 2010
- The influence of light-curing time on the bacterial colonization of resin composite surfacesDental Materials, 2009
- Influence of irradiant energy on degree of conversion, polymerization rate and shrinkage stress in an experimental resin composite systemDental Materials, 2008
- Minimal exposure time of different LED-curing devicesDental Materials, 2008
- The effect of different light-curing units on fatigue behavior and degree of conversion of a resin compositeDental Materials, 2005
- Correlation between recordings obtained with a light‐intensity tester and degree of conversion of a light‐curing resinEuropean Journal of Oral Sciences, 1994