Balancing processability and percolation behavior of ultrahigh aspect ratio carbon nanotubes in polymers through ball milling
Authors:
- 27 March 2025
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 46 (S1) , S747-S763
Abstract
The effects of ball milling on the processability and percolation behavior of ultralong (~100 μm) carbon nanotubes (CNTs) in an amorphous thermoplastic polymer, polycarbonate, were examined. The Burgio–Rojac model was applied to establish the relationship between impact energy and milled CNT morphology. The minimum single impact energy for fracture of ultralong CNTs (125 mJ/impact) was found to be nearly an order of magnitude greater than that of short, commercial CNTs (~10 mJ/impact) due to bundle diameter size differences. The kinetic length reduction behavior of ultralong CNTs was found to align with previously studied short CNTs, allowing for accurate prediction of CNT length reduction based on cumulative impact energy. Ball milling CNTs to 50, 20, and 5 μm lengths resulted in composite melt viscosity reductions of 26%, 52%, and 58%, respectively. A moderate increase in composite degradation temperature with increased CNT milling duration (+7°C for length reduction to 5 μm) suggested that polymer molecular weight is preserved. However, ball milling resulted in significant increases in rheological and electrical percolation thresholds vs. the unmilled CNTs due to the formation of small, undispersed agglomerates, suggesting a balance must be struck when employing ball milling as a processing aid for polymer composites filled with high aspect ratio fillers.Highlights: Length reduction kinetics of ultralong CNTs are similar to short CNTs. Ball milling CNTs improves composite processability by reducing agglomeration. Highly aligned CNT bundles do not disperse well during melt mixing. Ball milling CNTs results in an increased percolation threshold due to shortening.Keywords
Funding Information
- National Science Foundation
- University of Oklahoma
This publication has 83 references indexed in Scilit:
- Tune the phase morphology to design conductive polymer composites: A reviewPolymer Composites, 2017
- PMMA composites of single‐walled carbon nanotubes‐graft‐PMMAJournal of Applied Polymer Science, 2013
- Dynamic Electrical and Rheological Percolation in Isotactic Poly(propylene)/Carbon Black CompositesMacromolecular Materials and Engineering, 2011
- Carbon Nanotube Mass Production: Principles and ProcessesChemSusChem, 2011
- Recent Progress on the Growth Mechanism of Carbon Nanotubes: A ReviewChemSusChem, 2011
- Influence of processing conditions in small‐scale melt mixing and compression molding on the resistivity and morphology of polycarbonate–MWNT compositesJournal of Applied Polymer Science, 2009
- A Novel Strategy to Incorporate Carbon Nanotubes into Thermoplastic MatricesMacromolecular Rapid Communications, 2008
- Electrical and mechanical properties of carbon nanotube/ultrahigh‐molecular‐weight polyethylene composites prepared by a filler prelocalization methodJournal of Applied Polymer Science, 2007
- Melt Mixing of Polycarbonate with Multi‐Walled Carbon Nanotubes in Miniature MixersMacromolecular Materials and Engineering, 2006
- Carbon black filled conducting polymers and polymer blendsAdvances in Polymer Technology, 2002