High- and low-cycle fatigue influence of silicon, copper, strontium and iron on hypo-eutectic Al–Si–Cu and Al–Si–Mg cast alloys used in cylinder heads
Authors:
- Patrik HuterPHPatrik Huter
- Philipp RenhartPRPhilipp Renhart
- Stefan OberfrankSOStefan Oberfrank
- Martin SchwabMSMartin Schwab
- Florian GrünFGFlorian Grün
- Bernhard StauderBSBernhard Stauder
- 1 January 2016
- journal article
- Published by Elsevier in International Journal of Fatigue
- Vol. 82, 588-601
Abstract
No abstract availableKeywords
Funding Information
- Austrian Research Promotion Agency
This publication has 50 references indexed in Scilit:
- A Review on the Heat Treatment of Al-Si-Cu/Mg Casting Alloys2012
- Influence of Cu addition on microstructure and hardness of near-eutectic Al-Si-xCu-alloysTransactions of Nonferrous Metals Society of China, 2011
- High cycle fatigue strength of permanent mold and rheocast aluminum 357 alloyInternational Journal of Fatigue, 2010
- Fatigue properties and micromechanism of fracture of an alsimg0.6 cast alloy used in diesel engine cylinder headProcedia Engineering, 2010
- Lifetime of cast AlSi6Cu4 under superimposed thermal–mechanical fatigue and high-cycle fatigue loadingMaterials Science and Engineering: A, 2008
- Damage mechanisms of cast Al–Si–Mg alloys under superimposed thermal–mechanical fatigue and high-cycle fatigue loadingMaterials Science and Engineering: A, 2007
- A comparison of lifetime prediction methods for a thermal fatigue experimentInternational Journal of Fatigue, 2006
- A computational approach to thermomechanical fatigueInternational Journal of Fatigue, 2004
- Fatigue crack growth and fracture paths in sand cast B319 and A356 aluminum alloysMaterials Science and Engineering: A, 2003
- Fatigue analysis by local stress concept based on finite element resultsComputers & Structures, 2002