Effects of Air Speed and Liquid Temperature on Droplet Size
Authors:
- 1 April 2011
- journal article
- Published by ASTM International in Journal of ASTM International
- Vol. 8 (4) , 1-9
Abstract
Advancements in both application hardware (e.g., nozzles and spray assist devices) and spray property modification products have led to a number of products that are specifically designed to maximize the on-target deposition and minimize off-target movement of spray droplets. Testing protocols are being developed to objectively measure spray drift reduction from a wide range of drift reduction technologies (DRTs) including spray nozzles, sprayer modifications, spray delivery assistance, spray property modifiers (adjuvants), and/or landscape modifications. Using a DRT evaluation protocol, the objectives of this work were to study the effects of different air speeds on droplet size from different spray nozzles and spray solutions and to further evaluate the effects of differences in liquid and air temperature on droplet size at the different air speeds tested. Measured spray droplet size was significantly affected by changes in airspeed with the DV0.5 increasing by ∼30–100 μm and the percent of spray volume less than 200 μm decreasing by 50 % or more as the tunnel airspeed was increased from 0.5 to 6.7 m/s (1 to 15 miles per hour), depending on the spray solution, spray nozzle, and air speed. The data also showed a lesser influence of temperature differential between the spray solution and ambient air, with the differences seen most likely resulting from changes in spray solution physical properties with the changes in liquid temperature. Most importantly, this study demonstrated that a reference nozzle evaluated under the same conditions resulted in the reduction in driftable fines while the DRT remained constant across all conditions tested.Keywords
This publication has 11 references indexed in Scilit:
- Filtration Effects Due to Bioassay Cage Design and Screen Type1Journal of the American Mosquito Control Association, 2010
- Spray Drift Reduction Evaluations of Spray Nozzles Using a Standardized Testing ProtocolJournal of ASTM International, 2010
- Evaluation of Spray Drift Using Low-Speed Wind Tunnel Measurements and Dispersion ModelingJournal of ASTM International, 2010
- Impacts of Climate Change on Indirect Human Exposure to Pathogens and Chemicals from AgricultureEnvironmental Health Perspectives, 2009
- Evaluation of a Proposed Drift Reduction Technology High-Speed Wind Tunnel Testing ProtocolJournal of ASTM International, 2009
- Factors Influencing the Performance of Spray Delivery Systems: A Review of Recent DevelopmentsJournal of ASTM International, 2005
- TEMPERATURE EFFECTS ON ATOMIZATION BY FLAT-FAN NOZZLES: IMPLICATIONS FOR DRIFT MANAGEMENT AND EVIDENCE FOR SURFACTANT CONCENTRATION GRADIENTSAtomization and Sprays, 1998
- Intermittent Control of Liquid Flow from Fan Nozzles in Concurrent Air Streams: Wind Tunnel Studies of Droplet Size EffectsJournal of Agricultural Engineering Research, 1995
- Multiple Scattering Effects in Dense Spray Sizing by Laser DiffractionAerosol Science and Technology, 1990
- Drop-size measurement techniques for sprays: comparison of Malvern laser-diffraction and Aerometrics phase/DopplerApplied Optics, 1987