Emitter-ballasting-resistor-free SiGe microwave power heterojunction bipolar transistor
Authors:
- Hongyong JiaHJHongyong Jia
- Pei-Hsin TsienPTPei-Hsin Tsien
- Tai-Chin LoTLTai-Chin Lo
- 1 July 1999
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 20 (7) , 326-328
Abstract
The emitter ballasting resistor is used to equalize the current distribution between the emitter stripes in power transistor, but it will degrade the output power, power gain, and power added efficiency. Experimental results indicate that the current gain of uniform-base SiGe heterojunction bipolar transistors (HBTs) decreases with the increase of the temperature above 160 K, so the current distribution is equalized by itself to some extent. Therefore, the microwave power SiGe HBTs without emitter ballasting resistor were fabricated for the first time, and the continuous output power of 5 W and power added efficiency of 63% were obtained under Class C operation at a frequency of 900 MHz. Hence, the emitter current density of the SiGe HBT's with emitter width of 6 /spl mu/m is 0.79 A/cm.Keywords
This publication has 3 references indexed in Scilit:
- 1-W SiGe power HBTs for mobile communicationIEEE Microwave and Guided Wave Letters, 1996
- A 230-Watt S-band SiGe heterojunction bipolar transistorIEEE Transactions on Microwave Theory and Techniques, 1996
- BILOW-simulation of low-temperature bipolar device behaviorIEEE Transactions on Electron Devices, 1989