Automotive active suspensions Part 2: Practical considerations
Author:
- 1 June 1997
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering
- Vol. 211 (6) , 427-444
Abstract
Part 1 of the paper demonstrated the compromises required in suspension design brought about by the conflicting demands of ride and handling, and the constraints applied by the need to minimize body acceleration within a limited suspension travel. It then went on to show how a state feedback controller can be used to provide improvements in ride which are not achievable with standard passive components. This second part discusses the hardware employed, which ranges from simple switched dampers, through semi-active dampers, and low-bandwidth/soft active suspensions, to high-bandwidth/stiff active suspensions. The benefits to be derived from each of the technologies is assessed, together with the practical implications.Keywords
This publication has 6 references indexed in Scilit:
- Development of the Semi-Active Suspension System Based on the Sky-Hook Damper TheorySAE International Journal of Advances and Current Practices in Mobility, 1994
- On the Design of an Active Roll Control System for a Luxury CarProceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering, 1993
- Power Requirements for Vehicle Suspension SystemsVehicle System Dynamics, 1992
- On the Performance Capabilities of Active Automobile Suspension Systems of Limited BandwidthVehicle System Dynamics, 1987
- 1984 Continental Mark VII/Lincoln Continental Electronically-Controlled Air Suspension (EAS) SystemSAE International Journal of Advances and Current Practices in Mobility, 1984
- Hydragas® SuspensionSAE International Journal of Advances and Current Practices in Mobility, 1979