Pressure Trace Knock Measurement in a Current S.I. Production Engine
Authors:
- 1 February 1989
- conference paper
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Abstract
The use of cylinder pressure transducers in engine control systems will permit optimum performance under all operating conditions. Previous research has shown that it is possible to automatically detect and evaluate knocking combustion based on low frequency (1 point per crank angle degree) pressure data from research and production engines. However, the previous work was done in a single cylinder research engine and a production engine with relatively slow combustion and large knock pressure peaks. In this study, a spark-plug-mounted pressure transducer and an in-cylinder flush mounted pressure transducer were used to monitor the combustion pressure in a modern four cylinder engine during knocking and normal full load operation over a speed range of 1800 RPM to 4000 RPM. This engine features much more rapid combustion and much smaller knock pressure peaks. Pressure trace knock detection algorithms are compared with the output of the standard knock sensor (accelerometer) mounted on the intake manifold of the engine. It was found that the third derivative knock detection algorithm is able to adequately resolve knocking cycles and to provide a measure of knock severity directly from analysis of the pressure traces without being affected by stray vibrations from other sources. Due to the narrowness of the pressure peak caused by rapid combustion, the third derivative knock indicator is calculated from higher frequency (3.3 points per crank angle degree) pressure data rather than 1 point per degree.Keywords
This publication has 24 references indexed in Scilit:
- Intra-Cylinder Combustion Pressure SensingSAE International Journal of Advances and Current Practices in Mobility, 1987
- Factors Limiting the Improvement in Thermal Efficiency of S. I. Engine at Higher Compression RatioSAE International Journal of Advances and Current Practices in Mobility, 1987
- A Cylinder Pressure Sensor for Closed Loop Engine ControlSAE International Journal of Advances and Current Practices in Mobility, 1987
- Nissan's Present and Future Electronic Concentrated Engine Control SystemsSAE International Journal of Advances and Current Practices in Mobility, 1986
- New Trends in Electronic Engine Control - To the Next StageSAE International Journal of Advances and Current Practices in Mobility, 1986
- Knock Reduction of Spark-Ignition Engines by EGRSAE International Journal of Advances and Current Practices in Mobility, 1986
- The Knock Syndrome — Its Cures and Its VictimsSAE International Journal of Advances and Current Practices in Mobility, 1984
- Energy Conservation with Increased Compression Ratio and Electronic Knock ControlSAE International Journal of Advances and Current Practices in Mobility, 1979
- A Cylinder Pressure Sensor for Spark Advance Control and Knock DetectionSAE International Journal of Advances and Current Practices in Mobility, 1979
- The Effect of Exhaust Recycle on Knock-Limited SI Engine PerformanceSAE International Journal of Advances and Current Practices in Mobility, 1975