Alloys with a Cellular Dislocation Substructure: Hardening Mechanisms and Their Contributions to Flow Stresses
Open Access
- 5 April 2024
- journal article
- Published by Altai State University in Izvestiya of Altai State University
- No. 1(135),p. 67-75
Abstract
The study covers dilute Cu-Mn alloys with a cellular dislocation substructure formed during deformation. The contribution to the flow stress caused by the cellular dislocation substructure is evaluated, and relative roles of various deformation resistance mechanisms are determined. The analysis of electron microscopic images of thin foils of deformed low-alloy Cu-Mn alloys shows the contribution of various dislocation substructure parameters. Such parameters are the scalar dislocation density, dislocation densities in cell walls, boundaries of disoriented cells, ragged sub-boundaries, boundaries of band and fragmented substructures, and grain boundaries. It is found that the contribution of disorientations at cell boundaries increases along with the increase of the misoriented cell boundaries density and the disorientation angle. The efficiency of the cell walls performed as obstacles to sliding is related to the appearance of disorientations through the cell boundaries and their increase with increasing strain. The appearance of disorientations enhances the barrier drag effect in a cellular dislocation substructure.Keywords
This publication has 8 references indexed in Scilit:
- A crucial impact of short-range ordering on the cyclic deformation and damage behavior of face-centered cubic alloys: A case study on Cu-Mn alloysActa Materialia, 2021
- Anomalous recovery of work hardening rate in Cu-Mn alloys with high stacking fault energies under uniaxial compressionMaterials Science and Engineering: A, 2019
- A good strength-ductility match in Cu-Mn alloys with high stacking fault energies: Determinant effect of short range orderingScripta Materialia, 2017
- Исследование зёренной структуры сплавов Cu–Al и Cu–Mn методами дифракции обратно рассеянных электронов и оптической металлографииIzvestiâ Akademii nauk SSSR. Seriâ fizičeskaâ, 2014
- Internal fields and other contributions to flow stressMaterials Science and Engineering: A, 1997
- Regularities of substructural hardeningRussian Physics Journal, 1991
- A compilation and analysis of data for the stress dependence of the subgrain sizeMaterials Science and Engineering, 1986
- Nature of substructural hardeningRussian Physics Journal, 1982