Investigation of probing repeatability inside a micro-hole by changing probe approach direction for a local surface interaction force detection type microprobe
Authors:
Open Access
- 2 February 2023
- journal article
- research article
- Published by Frontiers Media SA in Frontiers in Manufacturing Technology
- Vol. 3
Abstract
The inner diameter measurement of the micro-hole was performed by a tactile microprobing system using a method of the local surface interaction force detection. The inner diameter of the micro-hole was calculated by the least square method based on the probing coordinates obtained by a custom-made micro-coordinate measuring machine. The dispersion of the probing coordinates was investigated by changing the probe approaching direction with respect to the normal direction of the inner side of the micro-hole. During the probing inside the micro-hole, it was confirmed that the dispersion of the probing coordinates increased when the disagreement between the probe approaching direction and the normal direction of the micro-hole at the measured point became large. The influence of the dispersion of the probing coordinates was evaluated through the uncertainty analysis of the inner diameter measurement. It was revealed that the uncertainty of the inner diameter measurement could be improved when limiting the disagreement between the probe approaching direction and the normal direction of the micro-hole to within ±pi/4 rad.Keywords
Funding Information
- Japan Society for the Promotion of Science London`
This publication has 31 references indexed in Scilit:
- Mechanism design and process control of micro EDM for drilling spray holes of diesel injector nozzlesPrecision Engineering, 2013
- Novel micro deep drilling using micro long flat drill with ultrasonic vibrationPrecision Engineering, 2012
- Aspects of tactile probing on the micro scalePrecision Engineering, 2011
- Application of modern high resolution tactile sensors for micro-objectsInternational Journal of Precision Technology, 2011
- A vibrating micro-scale CMM probe for measuring high aspect ratio structuresMicrosystem Technologies, 2009
- Form measurements of micro-holesMeasurement Science and Technology, 2007
- UV laser drilling of SiC for semiconductor device fabricationJournal of Physics: Conference Series, 2007
- Probing systems for dimensional micro- and nano-metrologyMeasurement Science and Technology, 2006
- Probing Systems in Dimensional MetrologyCIRP Annals, 2004
- Vibroscanning Method for Nondestructive Measurement of Small HolesCIRP Annals, 1993