Medium Voltage Converter Inductor Insulation Design Considering Grid Requirements
- 30 November 2021
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Emerging and Selected Topics in Power Electronics
- Vol. 10 (2) , 2339-2350
Abstract
Medium voltage SiC devices facilitate direct (without 50/60 Hz transformer) connection of the power electronics converter to the medium voltage grid using simple topology. Compared to the insulation design of medium voltage inductors that have been widely used in the power system, the insulation design of the medium voltage converter filter inductors has new challenges. Particularly, the grid impact on insulation requirements on converter filter inductors is rarely discussed. This paper introduces the insulation design of a grid-side filter inductor for a 13.8 kV power conditioning system converter. The grid insulation requirements, including the short-duration power frequency overvoltage and the lightning impulse voltage, are considered in the design. To meet the requirements, the layer-to-layer insulation, winding-to-core/ground insulation, the air gap discharge between the winding and the core, the local electric field, as well as the inter-turn transient voltage distribution are considered. The designed inductors are validated by the 46 kV (>1 minute) dc hi-pot test, 12 kV ac partial discharge test, one-hour single-phase converter full rating test, as well as three-phase converter full rating test.Keywords
Funding Information
- Advanced Manufacturing Office
- United States Department of Energy (DE-EE0008410)
- Engineering Research Center Program of the National Science Foundation
- Department of Energy under NSF (EEC-1041877)
- CURENT Industry Partnership Program
This publication has 14 references indexed in Scilit:
- Physics-Based Modeling of Parasitic Capacitance in Medium-Voltage Filter InductorsIEEE Transactions on Power Electronics, 2020
- Design and Verification of a Medium-Frequency Transformer in a Three-Phase Dual-Active Bridge DC-DC Converter for Medium-Voltage Grid Connection of Offshore Wind Farms2020
- 99% Efficient 10 kV SiC-Based 7 kV/400 V DC Transformer for Future Data CentersIEEE Journal of Emerging and Selected Topics in Power Electronics, 2018
- Experimental Verification on Thermal Modeling of Medium Frequency Transformers2018
- High Frequency Transformer Insulation in Medium Voltage SiC enabled Air-cooled Solid-State Transformers2018
- Novel insulation concept for an MV dry-cast medium-frequency transformer2017
- Solid-State Transformer and MV Grid Tie Applications Enabled by 15 kV SiC IGBTs and 10 kV SiC MOSFETs Based Multilevel ConvertersIEEE Transactions on Industry Applications, 2015
- Design and Demonstration of a 3.6-kV–120-V/10-kVA Solid-State Transformer for Smart Grid ApplicationIEEE Transactions on Power Electronics, 2013
- Accurate prediction of ferrite core loss with nonsinusoidal waveforms using only Steinmetz parameters2003
- Comparison of various methods for calculating the AC resistance of inductorsIEEE Transactions on Magnetics, 2002