Dynamics of dikes versus cone sheets in volcanic systems
Open Access
- 17 July 2014
- journal article
- research article
- Published by American Geophysical Union (AGU) in Journal of Geophysical Research: Solid Earth
- Vol. 119 (8) , 6178-6192
Abstract
Igneous sheet intrusions of various shapes, such as dikes and cone sheets, coexist as parts of complex volcanic plumbing systems likely fed by common sources. How they form is fundamental regarding volcanic hazards, yet no dynamic model simulates and predicts satisfactorily their diversity. Here we present scaled laboratory experiments that reproduced dikes and cone sheets under controlled conditions. Our models show that their formation is governed by a dimensionless ratio (Π1), which describes the geometry of the magma source, and a dynamic dimensionless ratio (Π2), which compares the viscous stresses in the flowing magma to the host rock strength. Plotting our experiments against these two numbers results in a phase diagram evidencing a dike and a cone sheet field, separated by a sharp transition that fits a power law. This result shows that dikes and cone sheets correspond to distinct physical regimes of magma emplacement in the crust. For a given host rock strength, cone sheets preferentially form when the source is shallow, relative to its lateral extent, or when the magma influx velocity (or viscosity) is high. Conversely, dikes form when the source is deep compared to its size, or when magma influx rate (or viscosity) is low. Both dikes and cone sheets may form from the same source, the shift from one regime to the other being then controlled by magma dynamics, i.e., different values of Π2. The extrapolated empirical dike‐to‐cone sheet transition is in good agreement with the occurrence of dikes and cone sheets in various natural volcanic settings.Keywords
Funding Information
- Norwegian Research Council (146031)
This publication has 57 references indexed in Scilit:
- Ardnamurchan 3D cone-sheet architecture explained by a single elongate magma chamberScientific Reports, 2013
- The association of cone–sheets and radial dykes: Data from the Isle of Skye (UK), numerical modelling, and implications for shallow magma chambersEarth and Planetary Science Letters, 2012
- Three-dimensional structure of inclined sheet swarms: Implications for crustal thickening and subsidence in the volcanic rift zones of IcelandJournal of Volcanology and Geothermal Research, 2009
- Emplacement mechanisms of sill complexes: Information from the geochemical architecture of the Golden Valley Sill Complex, South AfricaJournal of Volcanology and Geothermal Research, 2008
- Failure patterns caused by localized rise in pore‐fluid overpressure and effective strength of rocksGeophysical Research Letters, 2007
- Tectonics and magma dynamics coupling in a dyke swarm of IcelandJournal of Structural Geology, 2007
- An experimental investigation of sill formation and propagation in layered elastic mediaEarth and Planetary Science Letters, 2006
- Some tectonic consequences of fluid overpressures and seepage forces as demonstrated by sandbox modellingTectonophysics, 2003
- Shear test results for cohesion and friction coefficients for different granular materials: scaling implications for their usage in analogue modellingTectonophysics, 2000
- The dynamic emplacement of cone sheetsTectonophysics, 1974