Evaluation of micro-drilling technologies for metal-injection-molded 420 stainless steel
- 2 July 2016
- journal article
- research article
- Published by Taylor & Francis in Machining Science and Technology
- Vol. 20 (3) , 368-385
Abstract
Metal-injection-molded (MIM) 420 stainless steel is a commonly used material for high-value products such as fuel injector nozzles. However, the trade-offs involved in using different micro-drilling processes on this material are not well-documented in literature. This article presents a micro-drilling study of MIM 420 stainless steel using four candidate processes: micro-electrical discharge drilling (micro-EDD), ultrasonically assisted micro-EDD, micro-mechanical drilling (micro-MD), and ultrasonically assisted micro-MD. The micro-EDD results shows that the use of ultrasonic vibrations significantly improves the overall process time, spark erosion efficiency, and material removal rate of the process. However, this improvement comes at the expense of increased tool wear and surface roughness, especially while machining under high-discharge-energy conditions. The micro-MD results show that the use of ultrasonic vibrations is beneficial in lowering the thrust force, drilling torque, and tool wear at chipload values greater than the minimum chip thickness of the material. However, the ultrasonic vibrations do not have a notable effect on the surface roughness or on the size of the exit burrs. The results obtained from this study have been used to develop a Likert-type comparison scale to enable application-specific selection of micro-drilling processes for MIM 420 stainless steel.Keywords
This publication has 12 references indexed in Scilit:
- Experimental Investigation of the Machinability of Epoxy Reinforced With Graphene PlateletsJournal of Manufacturing Science and Engineering, 2013
- Novel micro deep drilling using micro long flat drill with ultrasonic vibrationPrecision Engineering, 2012
- Sequential laser and mechanical micro-drilling of Ni superalloy for aerospace applicationCIRP Annals, 2010
- Geometry and surface damage in micro electrical discharge machining of micro-holesJournal of Micromechanics and Microengineering, 2009
- Towards the effective tool wear control in micro-EDM millingThe International Journal of Advanced Manufacturing Technology, 2009
- The effect of facility size on manufacturing structure and performanceIndustrial Management & Data Systems, 2005
- An Analytical Model for the Prediction of Minimum Chip Thickness in MicromachiningJournal of Manufacturing Science and Engineering, 2005
- Aerospace adds lustre to appeal of master alloy MIM feedstocksMetal Powder Report, 2004
- Micro-EDM drilling of tapered holes for industrial applicationsJournal of Materials Processing Technology, 2004
- MIM Parts for Automotive Applications Production and Economic Aspects.Journal of the Japan Society of Powder and Powder Metallurgy, 1999