Studies of Spray Breakup and Mixture Stratification in a Gasoline Direct Injection Engine Using KIVA-3V
Authors:
- 7 January 2000
- journal article
- Published by ASME International in Journal of Engineering for Gas Turbines and Power
- Vol. 122 (3) , 485-492
Abstract
The Low Pressure spray Breakup (LPB) model of Papageorgakis and Assanis has been implemented in the multi-dimensional code KIVA-3V as an alternative to the standard Taylor Analogy Breakup (TAB) model. Comparison of spray predictions with measurements shows that the LPB model, in conjunction with the standard k-ε turbulence model, has the potential for simulating the evolution of hollow cone sprays with acceptable fidelity, both from qualitative and quantitative standpoints. After validating the LPB model, illustrative studies of mixture stratification are conducted for a Direct Injection Gasoline (DIG) combustion chamber resembling the Mitsubishi design. The effects of reverse tumble strength and injection timing on mixture quality in the vicinity of the spark plug are explored. Overall, the study demonstrates how the KIVA-3V code with the LPB model can contribute to the optimization and control of mixing in DIG engines. [S0742-4795(00)00303-3]Keywords
This publication has 19 references indexed in Scilit:
- COMPARISON OF LINEAR AND NONLINEAR RNG-BASED k-epsilon MODELS FOR INCOMPRESSIBLE TURBULENT FLOWSNumerical Heat Transfer, Part B: Fundamentals, 1999
- Development of Direct Injection Gasoline Engine - Study of Stratified Mixture FormationSAE International Journal of Advances and Current Practices in Mobility, 1997
- Multidimensional Modeling of Spray Atomization and Air-Fuel Mixing in a Direct-Injection Spark-Ignition EngineSAE International Journal of Advances and Current Practices in Mobility, 1997
- MODELING ATOMIZATION PROCESSES OF PRESSURE-SWIRL HOLLOW-CONE FUEL SPRAYSAtomization and Sprays, 1997
- Modeling the Effects of Intake Flow Structures on Fuel/Air Mixing in a Direct-injected Spark-Ignition EngineSAE International Journal of Advances and Current Practices in Mobility, 1996
- A spray breakup model for low injection pressuresInternational Communications in Heat and Mass Transfer, 1996
- Comparisons of Computed and Measured Hollow-Cone Sprays in an EngineSAE International Journal of Advances and Current Practices in Mobility, 1995
- Turbulence Modeling of Internal Combustion Engines Using RNG κ-ε ModelsCombustion Science and Technology, 1995
- The Tab Method for Numerical Calculation of Spray Droplet BreakupSAE International Journal of Advances and Current Practices in Mobility, 1987
- On the breakup of accelerating liquid dropsJournal of Fluid Mechanics, 1972