Effects of consumer use practices on nanosilver release from commercially available food contact materials
- 23 October 2018
- journal article
- research article
- Published by Taylor & Francis in Food Additives & Contaminants: Part A
- Vol. 35 (11) , 2279-2290
Abstract
Migration evaluation involving nano-enabled food contact materials (FCMs) mostly focuses on potential nanoparticle release from new unused products. This may not represent consumer use practices encountered by the FCMs in their lifecycle. In order to determine if product use impacts the release of nanoparticles or other FCM components, it is necessary to perform migration evaluations under typical consumer use scenarios. A quantitative assessment of nanoparticle release from a commercially available nanosilver-enabled cutting board was performed under five conditions intended to simulate consumer use. Knife motion, washing and scratching scenarios were simulated by linear abrasion using knife blades, scrubbing pads and tungsten carbide burr attachments, respectively. Migration was evaluated using water and 3% acetic acid as food simulants. Low concentrations of silver (Ag) were detected in water simulants, a small portion (−2) in the form of silver nanoparticles (AgNPs) with particle number concentrations on the order of 106 particles dm−2. Median particle diameter was 40 nm. Nanoparticle release into water was observed under all five consumer use scenarios studied, however there was no correlation with the different levels of stress simulated.Keywords
This publication has 24 references indexed in Scilit:
- Silver migration from nanosilver and a commercially available zeolite filler polyethylene composites to food simulantsFood Additives & Contaminants: Part A, 2014
- Nanoparticle release from nano-silver antimicrobial food containersFood and Chemical Toxicology, 2013
- Migration of silver from commercial plastic food containers and implications for consumer exposure assessmentFood Additives & Contaminants: Part A, 2013
- Determining Transport Efficiency for the Purpose of Counting and Sizing Nanoparticles via Single Particle Inductively Coupled Plasma Mass SpectrometryAnalytical Chemistry, 2011
- Applications of nanotechnology in food packaging and food safety: Barrier materials, antimicrobials and sensorsJournal of Colloid and Interface Science, 2011
- Nanotechnology in plastic food‐contact materialsJournal of Applied Polymer Science, 2011
- Nanosilver Migrated into Food‐Simulating Solutions from Commercially Available Food Fresh ContainersPackaging Technology and Science, 2011
- Evaluation of nanocomposite packaging containing Ag and ZnO on shelf life of fresh orange juiceInnovative Food Science & Emerging Technologies, 2010
- Applications and implications of nanotechnologies for the food sectorFood Additives & Contaminants: Part A, 2008
- Gold colloid analysis by inductively coupled plasma-mass spectrometry in a single particle modeAnalytica Chimica Acta, 2006