Influence of the PM-Processing Route and Nitrogen Content on the Properties of Ni-Free Austenitic Stainless Steel
Open Access
- 17 December 2014
- journal article
- research article
- Published by Springer Nature in Metallurgical and Materials Transactions A
- Vol. 46 (3) , 1154-1167
Abstract
Ni-free austenitic steels alloyed with Cr and Mn are an alternative to conventional Ni-containing steels. Nitrogen alloying of these steel grades is beneficial for several reasons such as increased strength and corrosion resistance. Low solubility in liquid and δ-ferrite restricts the maximal N-content that can be achieved via conventional metallurgy. Higher contents can be alloyed by powder-metallurgical (PM) production via gas–solid interaction. The performance of sintered parts is determined by appropriate sintering parameters. Three major PM-processing routes, hot isostatic pressing, supersolidus liquid phase sintering (SLPS), and solid-state sintering, were performed to study the influence of PM-processing route and N-content on densification, fracture, and mechanical properties. Sintering routes are designed with the assistance of thermodynamic calculations, differential thermal analysis, and residual gas analysis. Fracture surfaces were studied by X-ray photoelectron spectroscopy, secondary electron microscopy, and energy dispersive X-ray spectroscopy. Tensile tests and X-ray diffraction were performed to study mechanical properties and austenite stability. This study demonstrates that SLPS process reaches high densification of the high-Mn-containing powder material while the desired N-contents were successfully alloyed via gas–solid interaction. Produced specimens show tensile strengths >1000 MPa combined with strain to fracture of 60 pct and thus overcome the other tested production routes as well as conventional stainless austenitic or martensitic grades.Keywords
This publication has 18 references indexed in Scilit:
- Prediction of mechanical properties of Fe–Cr–Mo sintered steel in relationship with microstructureMaterials & Design (1980-2015), 2012
- Intensive Interstitial Strengthening of Stainless SteelsAdvanced Engineering Materials, 2008
- Ab initio development of a high-strength corrosion-resistant austenitic steelActa Materialia, 2008
- Nichtmagnetisierbarer warmbeständiger nichtrostender Stahl für WälzlagerMaterialwissenschaft und Werkstofftechnik, 2008
- Steel of Highest Fracture EnergyKey Engineering Materials, 2007
- Stainless Austenitic CrMnCN Steels of Superior Strength Part I: Alloy Design and PropertiesMaterials Science Forum, 2007
- Microstructure and mechanical behavior of porous sintered steelsMaterials Science and Engineering: A, 2005
- On the correlation between electron structure and short range atomic order in iron-based alloysActa Materialia, 2000
- Grain boundary strengthening in austenitic nitrogen steelsMaterials Science and Engineering: A, 1999
- The Effect of Nitrogen on Martensite Formation in a Cr-Mn-Ni Stainless SteelJournal de Physique IV, 1995