The Influence of Soldering Flux on Stability of Heterojunction and TOPCon Solar Cells
Open Access
- 3 February 2025
- journal article
- Published by Wiley in Progress in Photovoltaics: Research and Applications
- Vol. 34 (1) , 69-83
Abstract
Silicon heterojunction technology (HJT) and tunnel oxide passivated contact (TOPCon) solar cell technologies are expected to dominate the photovoltaic market in the coming years. However, there are still some concerns about the long‐term stability of these technologies. This work examines the effects of two widely used commercial soldering fluxes (Flux A and Flux B) on the stability of commercial silicon HJT and TOPCon solar cells. The soldering flux was applied to the solar cells, and the solar cells were annealed at 85°C under a relative humidity (RH) of 0%. The investigated TOPCon solar cells were found to be stable; however, significant degradation was observed in the HJT solar cells after only 50 h. The efficiency of the HJT cells decreased by ~61% rel with Flux A and ~55% rel with Flux B, respectively. We attribute part of the observed degradation to pores present in the HJT cell metallisation after printing, which allow the soldering flux to easily penetrate the contact and subsequently react with the paste constituents. In addition, we find that the indium tin oxide (ITO) layer is very sensitive to soldering flux, showing major cracks and significant peeling after 50 h of annealing. Consequently, this work shows that some soldering flux can react with the ITO layer, without requiring the presence of water. This suggests that certain types of soldering flux can harm HJT solar cells even after encapsulation without the need for moisture ingress. Therefore, paying more attention to the choice of soldering flux is essential, especially when working with HJT cells. It is strongly recommended that users perform comprehensive component analysis testing on soldering fluxes before their official use rather than solely relying on datasheets provided by suppliers.Keywords
This publication has 31 references indexed in Scilit:
- Optimization strategies for metallization in n-type crystalline silicon TOPCon solar cells: Pathways to elevated fill factor and enhanced efficiencyCurrent Applied Physics, 2024
- Reliability of transparent conductive oxide in ambient acid and implications for silicon solar cellseScience, 2024
- Sintering densification of ITO targets with low tin oxide content for depositing TCO films as electrodes of solar cellsCeramics International, 2023
- Potential‐free sodium‐induced degradation of silicon heterojunction solar cellsProgress in Photovoltaics: Research and Applications, 2023
- Techno‐economic analysis of the use of atomic layer deposited transition metal oxides in silicon heterojunction solar cellsProgress in Photovoltaics: Research and Applications, 2022
- Investigation of In2O3:SnO2 films with different doping ratio and application as transparent conducting electrode in silicon heterojunction solar cellSolar Energy Materials and Solar Cells, 2022
- The value of stability in photovoltaicsJoule, 2021
- Silver‐Based Radical Reactions: Development and InsightsAdvanced Synthesis & Catalysis, 2017
- Effects of SiOx barrier layer prepared by plasma-enhanced chemical vapor deposition on improvement of long-term reliability and production cost for Cu-plated amorphous Si/crystalline Si heterojunction solar cellsSolar Energy Materials and Solar Cells, 2017
- Halogen Corrosion of Metals1976