A Novel Low-Cost DIC-Based Residual Stress Measurement Device
Open Access
- 18 July 2022
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 12 (14) , 7233
Abstract
Residual stress often has a significant impact on part performance and lifetime. Existing measurement techniques using strain gauges or non-destructive methods are often expensive and time-consuming. This paper presents a low-cost, novel measurement device that uses digital image correlation with the hole-drilling method to quantify the magnitude and preferred orientation of these locked-in forces. A two-axis measurement device that rapidly drills and images the surface around the hole was developed to measure residual stresses as a function of depth with sub-millimetre resolution. Validation of the device and DIC methodology was performed using a four-point bending specimen and comparison with conventional strain gauge methods. The results showed strong correlations between the two measurement techniques, as well as the theoretical estimates. The total cost of production was estimated to be approximately £380, which is significantly cheaper than competitors. The device also substantially reduced the cost per measurement point (less than £1 vs. £50+) and shortened the experiment duration from 2 h per point to 45 min per measurement. A functional, rapid, economical device has been designed and produced, which is currently being used for residual stress analysis of industrial samples. The presented design is completely open-source, and the relevant links are provided.Keywords
This publication has 47 references indexed in Scilit:
- A simple method for residual stress measurements in thin films by means of focused ion beam milling and digital image correlationSurface and Coatings Technology, 2013
- Methods of measuring residual stresses in componentsMaterials & Design (1980-2015), 2012
- Residual stress influences on structural reliabilityEngineering Failure Analysis, 2011
- Evaluating Non‐Uniform Residual Stress by the Hole‐Drilling Method with Concentric and Eccentric Holes. Part I. Definition and Validation of the Influence FunctionsStrain, 2010
- Evaluation of Residual Stresses using Ring Core MethodEPJ Web of Conferences, 2010
- The Application of Digital Image Correlation for Measuring Residual Stress by Incremental Hole DrillingApplied Mechanics and Materials, 2008
- RESIDUAL STRESS MEASUREMENT USING THE HOLE DRILLING METHOD AND LASER SPECKLE INTERFEROMETRY: PART 1Experimental Techniques, 2003
- Quantification and improvement of the signal-to-noise ratio in a magnetic resonance image acquisition procedureMagnetic Resonance Imaging, 1996
- Measurement of residual-stress distribution by the incremental hole-drilling methodJournal of Materials Processing Technology, 1985
- Measurement of residual stresses by the hole-drilling method: Influence of hole eccentricityThe Journal of Strain Analysis for Engineering Design, 1979