Partial density of states in the CuInSe2 valence bands
Authors:
- 15 June 1997
- journal article
- conference paper
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 81 (12) , 7806-7809
Abstract
The valence band spectra of a vacuum cleaved CuInSe surface were measured with synchrotron radiation at photon energies between 16 and 95 eV. The strong dependence of the photoionization cross section of atomic levels between 28 and 60 eV is used to divide the valence band emissions into contributions from Se 4p and Cu 3d states in order to map the respective partial density of states. The derived partial density of Cu 3d states to the total valence band density of states is around 50% in the upper part of the valence band and about 75% at its maximum corresponding to non-bonding Cu d states.
Keywords
This publication has 17 references indexed in Scilit:
- Electronic structure of some I–III–VI2 chalcopyrite semiconductors studied by synchrotron radiationJournal of Applied Physics, 1992
- Site-specific surface interaction of adsorbed water and halogens on copper indium selenide (CuInSe2) surfacesThe Journal of Physical Chemistry, 1992
- Determination and observation of electronic defect levels in CuInSe2 crystals and thin filmsJournal of Vacuum Science & Technology A, 1991
- Valence Band Density of States of ZnSiP2Physica Status Solidi (b), 1990
- Comparative Photoemission Study of the CuInC Chalcopyrite CompoundsCrystal Research and Technology, 1990
- Quantitative studies of cleaved and sputtered CuInSe2 surfacesJournal of Vacuum Science & Technology A, 1984
- Angle-resolved x-ray photoelectron spectroscopyProgress in Surface Science, 1984
- Electronic structure of the ternary chalcopyrite semiconductors CuAl, CuGa, CuIn, CuAl, CuGa, and CuInPhysical Review B, 1983
- Angle-resolved measurements of the photoemission of electrons in the study of solidsAdvances in Physics, 1983
- Partial density of valence states of amorphous and crystalline AgInand CuInPhysical Review B, 1974