Effects of Process Conditions on Properties of Electroplated Ni Thin Films for Microsystem Applications
- 1 January 2006
- journal article
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 153 (10) , D155-D161
Abstract
The properties of electroplated Ni thin films have been systematically investigated as a function of plating temperature and current density. The resistivity and its temperature coefficient remain unchanged on varying the process conditions, though the values of these properties are approximately three times and one-half of those of bulk Ni material, respectively. Optimal conditions of J=2mA∕cm2J=2mA∕cm2 and 60°C60°C were found for stress-free Ni thin films. The modulus of elasticity of the Ni films is as high as that of bulk Ni (210GPa)(210GPa) when plated at high temperature and low current density, and then decreases linearly with increasing plating current density, down to 85GPa85GPa at a plating current density of 30mA∕cm230mA∕cm2 . It is believed that higher plating rates produced fine-grained structures of low density, leading to a high tensile stress and low modulus of elasticity, while lower plating rates produced a dense material with a modulus of elasticity close to that of bulk Ni and a compressive residual stress. A clear correlation between modulus of elasticity and the stress exists, which reveals that a material under high tensile stress may posses a low modulus of elasticity, and is not suitable for fabrication of microelectromechanical systems devices.Keywords
This publication has 35 references indexed in Scilit:
- Polymer micro piezo valve with a small dead volumeJournal of Micromechanics and Microengineering, 2003
- Near-zero curvature fabrication of miniaturized micromechanical Ni switches using electron beam cross-linked PMMAJournal of Micromechanics and Microengineering, 2003
- Electroplating Ni micro-cantilevers for low contact-force IC probingSensors and Actuators A: Physical, 2003
- Fabrication of a New Electrostatic Linear ActuatorJapanese Journal of Applied Physics, 2000
- Residual stresses in electrodeposits of nickel and nickel–iron alloysSurface and Coatings Technology, 1999
- High-rate through-mold electrodeposition of thick (<200 μm) NiFe MEMS components with uniform compositionJournal of Microelectromechanical Systems, 1999
- Electrostatically actuated micromechanical switchesJournal of Vacuum Science & Technology A, 1997
- Magnetic microactuation of polysilicon flexure structuresJournal of Microelectromechanical Systems, 1995
- Electrodeposition of 3D microstructures on siliconJournal of Micromechanics and Microengineering, 1993
- Composition, mechanical properties, and structure of electrodeposited cobalt–iron alloysJournal of Vacuum Science and Technology, 1974