Model resin permeation of fiber reinforcements after shear deformation
Authors:
- 1 October 1997
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 18 (5) , 642-648
Abstract
In liquid composite molding processes such as resin transfer molding and structural reaction injection molding, fiber reinforcements are formed with automated processes to conform to the complex shape of the mold cavity. Deformation of the fiber reinforcement during the forming operation can be characterized by factors such as the local surface curvature of the mold and the type of reinforcement. For bidirectional fiber fabrics, simple shear is the major deformation mode in the forming process. Deformation of the fiber reinforcement after being formed to the mold cavity shape results in variations of local fiber content. In addition, the network structure of the fiber reinforcement is also rearranged. This may cause some significant effects on the fiber permeability and result in a mold filling pattern quite different from that expected. Therefore, a good understanding and measurement of the permeabilities for the deformed fiber reinforcements is of great importance. In the flow simulation of the filling process, the success of the prediction depends greatly on the correct values of in‐plane permeabilities. A change of the in‐plane permeability of the fabric after shear deformation must be well understood before an accurate flow simulation can be obtained. This article investigates the permeability of fiber reinforcements in relation to different shear angles. Several flow experiments were conducted on bidirectional woven roving fabrics at different shear angles. Two relevant factors—the ratio of principal permeabilities and the direction of principal axes with respect to the orientation of the fabric—are studied to investigate their variations with respect to shear deformation of the fiber reinforcements. It is found that the angle shift of the principal axes increases with the shear angle. At the same time, the in‐plane permeability ration may decrease with the shear angle.Keywords
This publication has 32 references indexed in Scilit:
- Measurement of the Three-Dimensional Permeability of Fiber Preforms Using Embedded Fiber Optic SensorsJournal of Composite Materials, 1995
- Permeability of Unidirectional Reinforcements for RTMJournal of Composite Materials, 1992
- Permeability characteristics of multilayer fiber reinforcements. Part II: Theoretical modelPolymer Composites, 1991
- Simultaneous measurements of permeability and capillary pressure of thermosetting matrices in woven fabric reinforcementsPolymer Composites, 1991
- Permeability characteristics of multilayer fiber reinforcements. Part I: Experimental observationsPolymer Composites, 1991
- Analysis of resin injection molding in molds with preplaced fiber mats. I: Permeability and compressibility measurementsPolymer Composites, 1991
- Liquid flow in molds with prelocated fiber matsPolymer Composites, 1989
- Radial penetration of a viscous liquid into a planar anisotropic porous mediumInternational Journal of Multiphase Flow, 1988
- The Modelling of Mold Filling in Resin Transfer MoldingInternational Polymer Processing, 1986
- Forced in‐plane flow of an epoxy resin in fibrous networksPolymer Engineering & Science, 1986