Instrumented thermoforming of advanced thermoplastic composites. II: Dynamics of double curvature part formation and structure development from PEEK/carbon fiber prepreg tapes
Authors:
- 1 October 1991
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 12 (5) , 338-353
Abstract
Poly(ether ether ketone) (PEEK) carbon fiber prepreg tapes (APC‐2) have been thermoformed into a hemispherical double curvature part under a variety of processing conditions. Conventional matched die molding using aluminum molds (at 200°C) were not successful in thermoforming acceptable parts. Parts with severe wrinkling and folding were obtained. A novel three‐piece (steel) mold with built‐in sheet clamping arrangement was, therefore, designed and fabricated. This mold was used at 400°C temperature to thermoform parts from preheated preconsolidated laminates. More interestingly, using the above conditions, 8‐ and 16‐ply unconsolidated laminates could be directly thermoformed into parts that were microstructurally sound and exhibited good shape conformity. Results suggest a cycle time of 15 min, with scope for further reduction, if mold cooling is employed. Notwithstanding the simplicity of the thermoforming process, such a short cycle time compares quite favorably with cycle times of several hours for conventional thermosetting resin based composites.Keywords
This publication has 11 references indexed in Scilit:
- Thermoforming of advanced thermoplastic composites. I: Single curvature partsPolymer Composites, 1991
- Heat transfer effects on the processing‐structure relationships of polyetheretherketone (PEEK) based compositesPolymer Engineering & Science, 1988
- Survey of current status and future trends in reinforced plastics compositesPolymer Composites, 1987
- The Processing Science of Thermoplastic Structural CompositesInternational Polymer Processing, 1987
- The Processing of Thermoplastics Containing High Loadings of Long and Continuous Reinforcing FibersJournal of Polymer Engineering, 1986
- Continuous Fibre Reinforced Thermoplastics1986
- Processing with Aromatic Polymer Composites1986
- Thermoplastic vs. thermosetting structural compositesPolymer Composites, 1984
- Thermoplastic Carbon Fibre Composites1984
- The morphology of poly(aryl-ether-ether-ketone)Polymer, 1983