Low-temperature wafer bonding: a study of void formation and influence on bonding strength
Authors:
- 11 April 2005
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Microelectromechanical Systems
- Vol. 14 (2) , 368-382
Abstract
The void formation has been systematically observed for low-temperature (120/spl deg/C and 400/spl deg/C) Si-Si and SiO/sub 2/-SiO/sub 2/ wafer bonding techniques in function of the annealing time (from 70 to 595 h), pressure (low vacuum and atmospheric) and surface pretreatments. Mixed solution (H/sub 2/SO/sub 4/ and H/sub 2/O/sub 2/) standard cleaning, warm nitric acid and O/sub 2/-plasma-assisted surface pretreatments have been considered and compared. The void formation is clarified according to the void distribution and the measurement of surface energy. Long annealing time periods are considered in order to reach the saturation of the interface chemical reactions. Our experiments demonstrate that the origin of voids appearing in low temperature O/sub 2/-plasma-enhanced wafer bonding is related to the great quantity of chemical reaction products. It has been shown that optimized O/sub 2/-plasma pretreatment time can lead to void-free, uniform and high surface energy (over 2.0 J/m/sup 2/) wafer bonding. In the case of SiO/sub 2/-SiO/sub 2/ wafer bonding, our experimental results show that below a certain critical silicon dioxide thickness the reaction products cannot be absorbed totally and then voids occur. Presenting a higher surface energy than warm nitric acid O/sub 2/-plasma is an extremely promising surface pretreatment solution for the increasing demand of low-temperature wafer bonding techniques.Keywords
This publication has 26 references indexed in Scilit:
- Steady-state measurement of wafer bonding cracking resistanceSensors and Actuators A: Physical, 2004
- Room Temperature Wafer Bonding Using Oxygen Plasma Treatment in Reactive Ion Etchers With and Without Inductively Coupled PlasmaJournal of the Electrochemical Society, 2003
- Effects of Plasma Activation on Hydrophilic Bonding of Si and SiO[sub 2]Journal of the Electrochemical Society, 2002
- Wafer direct bonding: tailoring adhesion between brittle materialsMaterials Science and Engineering: R: Reports, 1999
- Low Vacuum Wafer BondingElectrochemical and Solid-State Letters, 1999
- Low temperature silicon direct bonding for application in micromechanics: bonding energies for different combinations of oxidesSensors and Actuators A: Physical, 1998
- A Model of Low‐Temperature Wafer Bonding And Its ApplicationsJournal of the Electrochemical Society, 1996
- Chemical Free Room Temperature Wafer To Wafer Direct BondingJournal of the Electrochemical Society, 1995
- A Simple Chemical Treatment for Preventing Thermal Bubbles in Silicon Wafer BondingJournal of the Electrochemical Society, 1995
- Low temperature wafer direct bondingJournal of Microelectromechanical Systems, 1994