A MEMS sensor for microscale force measurements
Authors:
- 8 January 2016
- journal article
- research article
- Published by IOP Publishing in Journal of Micromechanics and Microengineering
- Vol. 26 (2) , 025013
Abstract
This paper describes the development and testing of a new MEMS-based sensor device for microscale contact force measurements. A special MEMS cell was developed to reach higher lateral resolution than common steel-based load cells with foil-type strain gauges as mechanical-electrical converters. The design provided more than one normal force measurement point with spatial resolution in submillimeter range. Specific geometric adaption of the MEMS-device allowed adjustability of its measurement range between 0.5 and 5 N. The thin film nickel-chromium piezo resistors were used to achieve a mechanical-electrical conversion. The production process was realized by established silicon processing technologies such as deep reactive ion etching and vapor deposition (sputtering). The sensor was tested in two steps. Firstly, the sensor characteristics were carried out by application of defined loads at the measurement points by a push-pull tester. As a result, the sensor showed linear behavior. A measurement system analysis (MSA1) was performed to define the reliability of the measurement system. The measured force values had the maximal relative deviation of 1% to average value of 1.97 N. Secondly, the sensor was tested under near-industrial conditions. In this context, the thermal induced relaxation behavior of the electrical connector contact springs was investigated. The handling of emerging problems during the characterization process of the sensor is also described.Keywords
This publication has 12 references indexed in Scilit:
- Silicon based in-situ measurement system for flex loads on MLCCs in PCB manufacturing chainSensors and Actuators A: Physical, 2015
- Experimental study of PDMS bonding to various substrates for monolithic microfluidic applicationsJournal of Micromechanics and Microengineering, 2014
- Prototyping of a highly performant and integrated piezoresistive force sensor for microscale applicationsJournal of Micromechanics and Microengineering, 2014
- Micromachined force sensors using thin film nickel–chromium piezoresistorsJournal of Micromechanics and Microengineering, 2012
- Configuration Selection, Modeling, and Preliminary Testing in Support of Constant Force Electrical ConnectorsJournal of Electronic Packaging, 2006
- The electromechanical behavior of nichrome (80/20 wt.%) filmThin Solid Films, 2003
- Atomic-Sized Metallic Contacts: Mechanical Properties and Electronic TransportPhysical Review Letters, 1996
- Longitudinal and transverse strain sensitivity of nichrome filmsMaterials Science and Engineering: B, 1990
- The electromechanical properties of thin films and the thin film strain gaugeThin Solid Films, 1974
- Stress Relaxation and Fatigue of Two Electromechanical Spring Materials Strengthened by Thermomechanical ProcessingIEEE Transactions on Parts, Materials and Packaging, 1971