Dropwise Condensation in Ambient on a Depleted Lubricant-Infused Surface
Open Access
- 20 April 2023
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 15 (17) , 21679-21689
Abstract
Durability of a lubricant-infused surface (LIS) is critical for heat transfer, especially in condensation-based applications. Although LIS promotes dropwise condensation, each departing droplet condensate acts as a lubricant-depleting agent due to the formation of wetting ridge and cloaking layer around the condensate, thus gradually leading to drop pinning on the underlying rough topography. Condensation heat transfer further deteriorates in the presence of non-condensable gases (NCGs) requiring special experimental arrangements to eliminate NCGs due to a decrease in the availability of nucleation sites. To address these issues while simultaneously improving heat-transfer performance of LIS in condensation-based systems, we report fabrication of both fresh LIS and a lubricant-depleted LIS using silicon porous nanochannel wicks as an underlying substrate. Strong capillarity in the nanochannels helps retain silicone oil (polydimethylsiloxane) on the surface even after it is severely depleted under tap water. The effect of oil viscosity was investigated for drop mobility and condensation heat transfer under ambient conditions, i.e., in the presence of NCGs. While fresh LIS prepared using 5 cSt silicone oil exhibited a low roll-off angle (∼1°) and excellent water drop (5 μL) sliding velocity ∼66 mm s-1, it underwent rapid depletion as compared to higher viscosity oils. Condensation performed on depleted nanochannel LIS with higher viscosity oil (50 cSt) resulted in a heat-transfer coefficient (HTC) of ∼2.33 kW m-2 K-1, which is a ∼162% improvement over flat Si-LIS (50 cSt). Such LIS promote fast drop shedding as is evident from the little change in the fraction of drops with diameter -2 K-1 was achieved over the last 2 days. The ability of reported LIS to maintain long-term hydrophobicity and dropwise condensation will aid in designing condensation-based systems with improved heat-transfer performance.Keywords
Funding Information
- Office of Naval Research (N000141812357)
This publication has 59 references indexed in Scilit:
- Immersion Condensation on Oil-Infused Heterogeneous Surfaces for Enhanced Heat TransferScientific Reports, 2013
- Bioinspired self-repairing slippery surfaces with pressure-stable omniphobicityNature, 2011
- Rediscovering Silicones: “Unreactive” Silicones React with Inorganic SurfacesLangmuir, 2011
- Coating of a textured solidJournal of Fluid Mechanics, 2011
- Range of Applicability of the Wenzel and Cassie−Baxter Equations for Superhydrophobic SurfacesLangmuir, 2009
- Plasma treatment of polymers for surface and adhesion improvementNuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms, 2003
- Microfabricated adhesive mimicking gecko foot-hairNature Materials, 2003
- Dropwise condensation theory and experiment: A reviewProceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy, 2002
- Heat transfer in dropwise condensation at low steam pressures in the absence and presence of non-condensable gasInternational Journal of Heat and Mass Transfer, 1968
- Condensation heat transfer in the presence of noncondensables, interfacial resistance, superheating, variable properties, and diffusionInternational Journal of Heat and Mass Transfer, 1966