Linking Grain Boundary Microstructure to Stress Corrosion Cracking of Cold-Rolled Alloy 690 in Pressurized Water Reactor Primary Water
Authors:
- S.M. BruemmerSBS.M. Bruemmer
- M.J. OlsztaMOM.J. Olszta
- M.B. ToloczkoMTM.B. Toloczko
- L.E. ThomasLTL.E. Thomas
- 1 October 2012
- journal article
- Published by Association for Materials Protection and Performance (AMPP) in Corrosion
- Vol. 69 (10) , 953-963
Abstract
Grain boundary microstructures and microchemistries are examined in cold-rolled Alloy 690 (UNS N06690) materials and comparisons are made to intergranular stress corrosion cracking (IGSCC) behavior in pressurized water reactor (PWR) primary water. Chromium carbide precipitation is found to be a key aspect for materials in both the mill-annealed and thermally treated conditions. Cold rolling to high levels of reduction was discovered to produce small IG voids and cracked carbides in alloys with a high density of grain boundary carbides. The degree of permanent grain boundary damage from cold rolling was found to depend directly on the initial IG carbide distribution. For the same degree of cold rolling, alloys with few IG precipitates exhibited much less permanent damage. Although this difference in grain boundary damage appears to correlate with measured SCC growth rates, crack tip examinations reveal that cracked carbides appeared to blunt propagation of IGSCC cracks in many cases. Preliminary results suggest that the localized grain boundary strains and stresses produced during cold rolling promote IGSCC susceptibility and not the cracked carbides and voids.Keywords
This publication has 9 references indexed in Scilit:
- Insights into Stress Corrosion Cracking Mechanisms from High-Resolution Measurements of Crack-tip Structures and CompositionsMRS Proceedings, 2010
- Misorientation Mapping for Visualization of Plastic Deformation via Electron Back-Scattered DiffractionMicroscopy and Microanalysis, 2006
- High-Resolution Characterization of Intergranular Attack and Stress Corrosion Cracking of Alloy 600 in High-Temperature Primary WaterCorrosion, 2000
- The deformation behaviour of grain boundary regions in polycrystalline aluminiumPhilosophical Magazine A, 1996
- Influence of Chromium Depletion on Intergranular Stress Corrosion Cracking of 304 Stainless SteelCorrosion, 1992
- Quantitative deformation studies using electron back scatter patternsActa Metallurgica et Materialia, 1991
- Behavior of grain boundary chemistry and precipitates upon thermal treatment of controlled purity alloy 690Metallurgical Transactions A, 1990
- Grain-Boundary Chemistry and Intergranular Fracture in Austenitic Nickel-Base Alloys—A ReviewCorrosion, 1990
- The effects of heat treatment on the chromium depletion, precipitate evolution, and corrosion resistance of INCONEL alloy 690Metallurgical Transactions A, 1989