Research on the printability of hydrogels in 3D bioprinting
Top Cited Papers
Open Access
- 20 July 2016
- journal article
- research article
- Published by Springer Nature in Scientific Reports
- Vol. 6 (1) , 29977
Abstract
As the biocompatible materials, hydrogels have been widely used in three- dimensional (3D) bioprinting/organ printing to load cell for tissue engineering. It is important to precisely control hydrogels deposition during printing the mimic organ structures. However, the printability of hydrogels about printing parameters is seldom addressed. In this paper, we systemically investigated the printability of hydrogels from printing lines (one dimensional, 1D structures) to printing lattices/films (two dimensional, 2D structures) and printing 3D structures with a special attention to the accurate printing. After a series of experiments, we discovered the relationships between the important factors such as air pressure, feedrate, or even printing distance and the printing quality of the expected structures. Dumbbell shape was observed in the lattice structures printing due to the hydrogel diffuses at the intersection. Collapses and fusion of adjacent layer would result in the error accumulation at Z direction which was an important fact that could cause printing failure. Finally, we successfully demonstrated a 3D printing hydrogel scaffold through harmonize with all the parameters. The cell viability after printing was compared with the casting and the results showed that our bioprinting method almost had no extra damage to the cells.Keywords
This publication has 45 references indexed in Scilit:
- Bio-ink properties and printability for extrusion printing living cellsBiomaterials Science, 2013
- 3D Bioprinting of heterogeneous aortic valve conduits with alginate/gelatin hydrogelsJournal of Biomedical Materials Research Part A, 2012
- Sodium Alginate Hydrogel-Based Bioprinting Using a Novel Multinozzle Bioprinting SystemArtificial Organs, 2011
- Scaffold-free 3D cellulose acetate membrane-based cultures form large cartilaginous constructsJournal of Tissue Engineering and Regenerative Medicine, 2011
- Polymeric Aqueous Biphasic Systems for Non‐Contact Cell Printing on Cells: Engineering Heterocellular Embryonic Stem Cell NichesAdvanced Materials, 2010
- Scaffold-free vascular tissue engineering using bioprintingBiomaterials, 2009
- Biocompatible Inkjet Printing Technique for Designed Seeding of Individual Living CellsTissue Engineering, 2005
- Multi‐nozzle deposition for construction of 3D biopolymer tissue scaffoldsRapid Prototyping Journal, 2005
- Rapid Prototyping of Tissue-Engineering Constructs, Using Photopolymerizable Hydrogels and StereolithographyTissue Engineering, 2004
- Three-Dimensional BioAssembly Tool for Generating Viable Tissue-Engineered ConstructsTissue Engineering, 2004