Microstructure Evolution and Tensile Behaviour of a Cold Rolled 8 Wt Pct Mn Medium Manganese Steel
Authors:
Open Access
- 23 November 2021
- journal article
- research article
- Published by Springer Nature in Metallurgical and Materials Transactions A
- Vol. 53 (2) , 597-609
Abstract
A novel medium manganese steel with composition Fe–8.3Mn–3.8Al–1.8Si–0.5C–0.06V–0.05Sn was developed and thermomechanically processed through hot rolling and intercritical annealing. The steel possessed a yield strength of 1 GPa, tensile strength of 1.13 GPa and ductility of 41 pct. In order to study the effect of cold rolling after intercritical annealing on subsequent tensile properties, the steel was further cold rolled up to 20 pct reduction. After cold rolling, it was observed that the strain hardening rate increased continuously with increasing cold rolling reduction but without a significant drop in ductility during subsequent tensile tests. The microstructural evolution with cold rolling reduction was analysed to understand the mechanisms behind this phenomena. It was found that cold rolling activated additional twinning systems which provided a large number of potent nucleation sites for strain induced martensite to form during subsequent tensile tests in what can be described as an enhanced TRIP effect.Keywords
All Related Versions
This publication has 63 references indexed in Scilit:
- Experimental and numerical analysis on formation of stable austenite during the intercritical annealing of 5Mn steelActa Materialia, 2011
- Design of a novel Mn-based 1GPa duplex stainless TRIP steel with 60% ductility by a reduction of austenite stabilityActa Materialia, 2011
- Effect of stress triaxiality and Lode angle on the kinetics of strain-induced austenite-to-martensite transformationActa Materialia, 2011
- Deformation-induced martensitic transformation behavior in cold-rolled and cold-drawn type 316 stainless steelsActa Materialia, 2010
- Influence of addition elements on the stacking-fault energy and mechanical properties of an austenitic Fe–Mn–C steelMaterials Science and Engineering: A, 2008
- Material Evaluation to Prevent Nozzle Clogging during Continuous Casting of Al Killed Steels.ISIJ International, 2002
- Influence of phase transformations on the mechanical properties of austenitic stainless steelsInternational Journal of Plasticity, 2000
- Martensite and deformation twinning in austenitic steelsMaterials Science and Engineering: A, 1999
- A mechanism for the strain-induced nucleation of martensitic transformationsJournal of the Less Common Metals, 1972
- Partial dislocations on the {110} planes in the B.C.C. lattice and the transition of the F.C.C. into the B.C.C. latticeActa Metallurgica, 1964