ITAC: A complete 3D integration test platform
Authors:
- 1 November 2016
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-4
Abstract
System integration takes benefit from 3D stacking technology in a wide range of applications such as smart imagers, photonic, wide I/O memories and high-performance computing. The 700 mm 2 ITAC 3D integration test platform contains a set of “Integrated Technological and Application Circuits” for process development, electrical and RF characterization, reliability, die stacking, warpage and underfilling studies, DC-DC converter and IntAct chip which is the full application chip. After a brief presentation of the targeted high performance computing application. The contributions integrated in the test platform are described with a particular focus on the 10 μm diameter 20 μm pitch die-to-die interconnects which is the key technology of the 3D stack. These test vehicles have been embedded on the same silicon to secure the application chip at all the steps from technology development to assembly and test.Keywords
This publication has 6 references indexed in Scilit:
- Mass Transport-Induced Failure of Hybrid Bonding-Based Integration for Advanced Image Sensor Applications2016
- Reliable 300 mm Wafer Level Hybrid Bonding for 3D Stacked CMOS Image Sensors2016
- New challenges and opportunities for 3D integrations2015
- 3D ICs: An opportunity for fully-integrated, dense and efficient power supplies2015
- Architectural exploration of a fine-grained 3D cache for high performance in a manycore context2013
- A 3D IC BIST for pre-bond test of TSVs using ring oscillators2013