Effect of stirring on the emulsion polymerization of styrene
Authors:
- 1 April 1972
- journal article
- research article
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 16 (4) , 835-847
Abstract
The purpose of this paper is to clarify the effect of stirring on the course of emulsion polymerization of, for example, styrene. It establishes the existence of an optimum range of stirring speed and three important factors which must be considered in carrying out emulsion polymerization. (1) Stirring significantly affects the course of reaction in the presence of an imperfectly purified nitrogen atmosphere. Consequently, the number of polymer particles produced and the polymerization rate per particle will be affected. (2) At higher stirring speeds, polymer particles coagulate and coalesce. At lower stirring speeds, the reaction rate is controlled by the monomer transport rate from monomer droplets to the aqueous phase. (3) Stirring contributes to the reduction of the number of micelles because emulsifier molecules are adsorbed onto the surfaces of monomer droplets finely dispersed by the stirring. At low emulsifier concentrations near the critical micelle concentration, this effect cannot be neglected.Keywords
This publication has 7 references indexed in Scilit:
- Rate of emulsion polymerization of styreneJournal of Applied Polymer Science, 1972
- THE EFFECT OF AGITATION ON THE RATE OF EMULSION POLYMERIZATION OF STYRENEJOURNAL OF CHEMICAL ENGINEERING OF JAPAN, 1969
- Mechanism of emulsion polymerization of vinylidene chloride. III. Effects of stirring rate on kineticsJournal of Applied Polymer Science, 1961
- Statistical Theories of Turbulence in Predicting Particle Size in Agitated DispersionsIndustrial & Engineering Chemistry, 1960
- Remark on the article by S. R. Shunmukham, V. L. Hallenbeck, and R. L. Guile, “Emulsion Polymerization of Styrene. II. Effect of Agitation”Journal of Polymer Science, 1951
- Emulsion polymerization of styrene. II. Effect of agitationJournal of Polymer Science, 1951
- A modified method for the determination of anionic surface active compoundsJournal of the American Oil Chemists' Society, 1951