Multi Response Optimization on Machinability of SiC Waste Fillers Reinforced Polymer Matrix Composite Using Taguchi’s Coupled Grey Relational Analysis
- 28 October 2020
- journal article
- research article
- Published by Springer Nature in Silicon
- Vol. 14 (1) , 65-73
Abstract
No abstract availableKeywords
This publication has 30 references indexed in Scilit:
- Wire Electric Discharge Machining of Silica Rich E-waste CRT and BN Reinforced Hybrid Magnesium MMCSilicon, 2018
- Doping Effect of SiC over Graphene on Dry Sliding Wear Behaviour of Mg/SiC@r-GO MMCs and its Surface CharacterizationSilicon, 2018
- ANFIS modeling of surface roughness in abrasive waterjet machining of carbon fiber reinforced plasticsJournal of Mechanical Science and Technology, 2017
- Experimental investigation and optimization of abrasive water jet cutting parameters for the improvement of cut quality in carbon fiber reinforced plastic laminatesJournal of Industrial Textiles, 2017
- Performance Evaluation of Abrasive Water Jet Machining on Banana Fiber Reinforced Polyester CompositeJournal of Natural Fibers, 2016
- Optimisation of machine components in thermal bonding process of nonwovens: Effect of the conveyer belt on the porous web performanceJournal of Industrial Textiles, 2016
- Evaluation of mechanical behaviour of nanometer and micrometer fly ash particle-filled woven bidirectional jute/glass hybrid nanocompositesJournal of Industrial Textiles, 2014
- Thermo-Mechanical Properties and Abrasive Wear Behavior of Silicon Carbide Filled Woven Glass Fiber CompositesSilicon, 2014
- Silane-Treated E-Glass Fiber-Reinforced Telechelic Macromer-Based Polymer-Matrix CompositesSilicon, 2013
- Investigation on glass/epoxy composite surfaces machined by abrasive water jet machiningJournal of Materials Processing Technology, 2008