Analysis of micro-cracks on machined surfaces in dry electrical discharge machining
Authors:
- P. GovindanPGP. Govindan
- Suhas S. JoshiSJSuhas S. Joshi
- 1 August 2012
- journal article
- Published by Elsevier in Journal of Manufacturing Processes
- Vol. 14 (3) , 277-288
Abstract
No abstract availableThis publication has 23 references indexed in Scilit:
- Effect of machining parameters on surface textures in EDM of Fe-Mn-Al alloyMaterials Science and Engineering: A, 2007
- Residual stresses and white layer in electric discharge machining (EDM)Applied Surface Science, 2007
- AFM surface imaging of AISI D2 tool steel machined by the EDM processApplied Surface Science, 2005
- A review on the use of environmentally-friendly dielectric fluids in electrical discharge machiningJournal of Materials Processing Technology, 2004
- Dry WEDM for Finish CutKey Engineering Materials, 2004
- Improvement of Dry EDM Characteristics Using Piezoelectric ActuatorCIRP Annals, 2004
- High Speed 3D Milling by Dry EDMCIRP Annals, 2003
- Electrical Discharge Machining in GasCIRP Annals, 1997
- Experimental investigation on migration of material during EDM of die steel (T215 Cr12)Journal of Materials Processing Technology, 1996
- Macroscopic and microscopic phenomena of electro-discharge machined steel surfaces: An experimental investigationJournal of Materials Processing Technology, 1987