A Study of the Functionality of Hydrated Lime as an Admixture
Authors:
Open Access
- 4 November 2014
- journal article
- Published by Canadian Center of Science and Education in Journal of Materials Science Research
- Vol. 4 (1) , p1
Abstract
It is known that hydrated lime improves the workability and water retention of Portland cement (PC) mortars. PC-lime mixes can be reworked without increasing entrained air thus not undermining durability. In addition, lime lowers strength and stiffness making PC mortars more deformable. However, the use of hydrated lime in PC composites has largely decreased due to the use of plasticisers. These enhance workability and lower cement content reducing heat of hydration. As they are water reducers, they are expected to decrease permeability, minimise shrinkage, enhance ultimate strength and accelerate early-strength gain; leading to stronger, durable composites. Despite these advantages, plasticisers have drawbacks related to wastage and environmental protection. This paper studies the properties of PC-lime mortars and their plasticised equivalents. It concludes that lime raises mortar water demand however, this does not reduce strength but on the contrary, mortars of low lime content (lime amounting 1/4 th the cement), have superior flexural and compressive strengths than their plasticised equivalents. The use of lime delivered PC mortars with excellent workability and surface finish and lack of segregation and bleeding. It is concluded that, when lime amounts 1/4 th the cement, the mortars are stronger (in tension and compression, at both early and mature age) and gain strength at a faster rate than plasticised mixes. However, when lime equals the cement content, strengths are lower than those of plasticised mixes. It was also noted that lime enhanced bond strength at all ages; and that the ultimate bond strength is greater for the low lime than for the high lime content mortars.Keywords
This publication has 6 references indexed in Scilit:
- Flexural bond strength of natural hydraulic lime mortar and clay brickMaterials and Structures, 2009
- Preparation of a new lignosulfonate-based thinner: introduction of ferrous ionsColloids and Surfaces A: Physicochemical and Engineering Aspects, 2002
- The effects of lime and admixtures on the water-retaining properties of cement mortarsCement and Concrete Research, 1999
- Chemical Admixtures for Concrete1999
- Flexural bond strength of masonry using various blocks and mortarsMaterials and Structures, 1996
- Flexural Bond Strength of Concrete Masonry Prisms Using Portland Cement and Hydrated Lime MortarsThe Masonry Society Journal, 1991