Fill ratio effects on vapor chamber thermal resistance with different configuration structures
Authors:
- Songkran WiriyasartSWSongkran Wiriyasart
- Paisarn NaphonPNPaisarn Naphon
- 1 December 2018
- journal article
- research article
- Published by Elsevier in International Journal of Heat and Mass Transfer
- Vol. 127, 164-171
Abstract
No abstract availableKeywords
Funding Information
- Srinakharinwirot University
This publication has 49 references indexed in Scilit:
- Condensation heat transfer on pin-fin tubes: Effect of thermal conductivity and pin heightApplied Thermal Engineering, 2013
- Feasibility study of an aluminum vapor chamber with radial grooved and sintered powders wick structuresApplied Thermal Engineering, 2013
- On the thermal cooling of central processing unit of the PCs with vapor chamberInternational Communications in Heat and Mass Transfer, 2012
- Copper foam based vapor chamber for high heat flux dissipationExperimental Thermal and Fluid Science, 2012
- Enhanced Condensation of Ethylene Glycol on Single Pin-Fin Tubes: Effect of Pin GeometryJournal of Heat Transfer, 2011
- Transient cooling of electronic components by flat heat pipesApplied Thermal Engineering, 2011
- A novel vapor chamber and its performanceInternational Journal of Heat and Mass Transfer, 2010
- Numerical simulation of a heat sink embedded with a vapor chamber and calculation of effective thermal conductivity of a vapor chamberApplied Thermal Engineering, 2009
- Thermal performance of flat vapor chamber heat spreaderEnergy Conversion and Management, 2008
- Numerical analysis and experimental verification on thermal fluid phenomena in a vapor chamberApplied Thermal Engineering, 2006