Gypsum Binder With Increased Water Resistance Derived From Membrane Water Desalination Waste
Open Access
- 20 October 2024
- journal article
- research article
- Published by Wiley in Engineering Reports
- Vol. 7 (1)
Abstract
A method has been developed for separating a mixture of calcium, magnesium and sodium sulfates obtained through the interaction of sulfuric acid and waste from the water purification process generated by using membrane filters. The primary goal of this method is to extract gypsum and produce gypsum‐based binders. Patterns were identified regarding how various types, ratio and quantities of additives: blast furnace slag, granite screenings, portland cement, electric steel smelting slag affect the water‐gypsum ratio, strength properties, and water resistance of high‐strength gypsum binders. It was found that adding a single‐component additive specifically to enhance water resistance does not significantly impact these properties. Complex additives have been developed based on Portland cement, granulated blast furnace slag, electric furnace slag, expanded clay dust, and granite screenings of various fractions. These additives are designed to maximize the water resistance of high‐strength gypsum binder based on synthetic calcium sulfate dihydrate. As a result, the water resistance coefficient increased from 0.45 to 0.52. Additionally, a technological block diagram of the process has been proposed.Keywords
This publication has 49 references indexed in Scilit:
- Preparation of calcium sulfate from recycled red gypsum to neutralize acidic wastewater and application of high silica residueJournal of Material Cycles and Waste Management, 2024
- Low energy synthesis of anhydrite cement from waste lime mudJournal of Chemical Technology & Biotechnology, 2022
- Paper industry slag for the production of building ceramicsJournal of Chemical Technology & Biotechnology, 2022
- Structurally controlled synthesis of synthetic gypsum derived from industrial wastes: sustainable approachJournal of Chemical Technology & Biotechnology, 2021
- Pigments from spent ammonium chloride zinc plating electrolytesJournal of Chemical Technology & Biotechnology, 2021
- Low‐energy technology for producing anhydrite in the CaCO3–H2SO4–H2O system derived from industrial wastesJournal of Chemical Technology & Biotechnology, 2021
- The Role of the Structure and Texture of the Gypsum Matrix in the Formation of Composite Materials2020
- General procedure for determining cellulose nanocrystal sulfate half-ester content by conductometric titrationCellulose, 2014
- Crop response to fine and granular magnesium fertilizersNutrient Cycling in Agroecosystems, 1988
- Studies on the preparation of calcium sulphate hemihydrate by an autoclave processJournal of Chemical Technology & Biotechnology, 1968