Compensating angle estimation errors caused by magnetic saturation in anisotropy-based sensorless control schemes
Authors:
- 1 September 2012
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 21666725,p. 1-6
Abstract
In anisotropy-based sensorless control schemes, the influence of magnetic saturation is usually neglected. This causes angle estimation errors, especially under high-load conditions. By applying a more accurate machine model, this error can be effectively compensated. The present work gives a short introduction to the non-linear model applied and analyzes the angle errors in both, open-loop and closed-loop sensorless operation. Additionally, an algorithm is proposed, that uses the model information to compensate the angle estimation error. The effectiveness of this approach is verified by measurements on a synchronous reluctance machine.Keywords
This publication has 11 references indexed in Scilit:
- Saliency-based sensorless predictive torque control with reduced torque rippleIEEE Transactions on Power Electronics, 2012
- Effect of stator and rotor saturation on sensorless rotor position detection2011
- Anisotropy Comparison of Reluctance and PM Synchronous Machines for Position Sensorless Control Using HF Carrier InjectionIEEE Transactions on Power Electronics, 2009
- Improved Rotor-Position Estimation by Signal Injection in Brushless AC Motors, Accounting for Cross-Coupling Magnetic SaturationIEEE Transactions on Industry Applications, 2009
- Predicted and measured errors in estimating rotor position by signal injection for salient-pole PM synchronous motors2009
- Effect of Rotor Geometry and Magnetic Saturation in Sensorless Control of PM Synchronous MachinesIEEE Transactions on Magnetics, 2009
- Measurement and Adaptive Decoupling of Cross-Saturation Effects and Secondary Saliencies in Sensorless Controlled IPM Synchronous MachinesIEEE Transactions on Industry Applications, 2008
- A New Speed-Varying Ellipse Voltage Injection Method for Sensorless Drive of Permanent-Magnet Synchronous Motors With Pole Saliency—New PLL Method Using High-Frequency Current Component Multiplied SignalIEEE Transactions on Industry Applications, 2008
- Cross-Saturation Effects in IPM Motors and Related Impact on Sensorless ControlIEEE Transactions on Industry Applications, 2006
- Sensorless speed and position control of synchronous machines using alternating carrier injection2003