Development and Validation of Novel FE Models for 3D Analysis of Peening of Strain-Rate Sensitive Materials
Authors:
- 17 August 2006
- journal article
- Published by ASME International in Journal of Engineering Materials and Technology
- Vol. 129 (2) , 271-283
Abstract
In this paper, we provide two different symmetry cells to describe the shot-peening process. In this multiple impingement model, we study the dynamic behavior of TI-6Al-4V targets subjected to a large number of shots. Three-dimensional elastoplastic finite element analysis (FEA) of the process was conducted using these two symmetry cells for strain-rate sensitive targets and rigid shots. The basic symmetry cell is assigned a target surface area , where is one half of separation distance between adjacent shots. The second “enhanced” symmetry cell is assigned a target surface area thus allowing higher density of impact point locations. Average residual stresses inside the target predicted by FEA were compared with experimental measurements using the hole-drilling technique. In order to do this, a new averaged technique was developed to obtain the stress distribution inside the symmetry cell. The results reveal that both symmetry cell models could be used for shot-peening modeling. However, the use of the enhanced symmetry cell leads to a better agreement with the measured residual stresses. In addition, the enhanced symmetry cell model allowed us to overcome some of the shortcomings of the basic symmetry cell for cases involving high peening velocity and intensity.
Keywords
This publication has 11 references indexed in Scilit:
- 3D FE analysis of peening of strain-rate sensitive materials using multiple impingement modelInternational Journal of Impact Engineering, 2002
- Finite element modelling of shot-peening residual stressesJournal of Materials Processing Technology, 1999
- Simulation of residual stresses by shot peeningComputers & Structures, 1999
- Three-dimensional dynamic finite element analysis of shot-peening induced residual stressesFinite Elements in Analysis and Design, 1999
- Mechanism of creation of compressive residual stress by shot peeningInternational Journal of Fatigue, 1998
- Simulation of Residual Stress Distribution on Shot PeeningJournal of the Society of Materials Science, Japan, 1995
- Mechanical approach to the residual stress field induced by shot peeningMaterials Science and Engineering: A, 1991
- Elasto-plastic co-indentation analysis of a bounded solid using finite element methodInternational Journal of Mechanical Sciences, 1985
- An examination of the relevance of co-indentation studies to incomplete coverage in shot-peening using the finite-element methodJournal of Materials Processing Technology, 1985
- On the Plastic Flow Beneath a Blunt Axisymmetric IndenterJournal of Engineering for Industry, 1970